Will 14' Hobie Pro Angler Kayak Fit on Malone MicroSport LowBed 2 Tier Trailer

Question

Question:

I have a Hobie Pro Angler 14 Kayak. It’s 38” wide and 14’ long. Will my kayak fit in the trailer?

asked by: Erik

0

Expert Reply:

Yes, your 14' Long Hobie Pro Angler Kayak will fit on the Malone MicroSport LowBed 2 Tier Trailer # MPG464-LBT.

If you're needing a kayak carrier then I recommend the Malone MegaWing Fishing Kayak Carrier with Tie-Downs # MPG207 which fits around the crossbars and has a 150 lb weight capacity.

Please note that you'll want to put some weight on the other side of the trailer as well to help make sure it sits nice and level.

expert reply by: Jon G

0

Answer 1

That's an excellent question, and you've got a good eye because the crossbars are about an inch lower than the fenders on the Malone 2 Tier LowBed MicroSport Trailer - 78" Crossbars #MPG464-LBT. So if you wanted to lay lumber completely…

view full answer...

Answer 2

The Malone MicroSport LowBed 2 #MPG464-LBT has 36" between the top and bottom crossbars. This trailer is the perfect solution for carrying kayaks, paddleboards, bikes, cargo carriers and any other outdoor gear that can be mounted on roof rack…

view full answer...

Answer 3

The Malone MicroSport LowBed 2 Tier Trailer part #MPG464-LBT would be the perfect option for a kayak and two bikes. The lower level is for boats which require the larger bar spread and the top is for smaller items like cargo boxes, bikes, etc. since…

view full answer...

Answer 4

The retractable tongue kit part #MPG494 that you referenced works perfectly fine with the Malone Microsport Lowbed part #MAL25FR that you also referenced.

view full answer...

Answer 5

Hey Geoff, I spoke with Thule and they stated that the correct replacement lid lifter hinge for your Thule Force XT XXL cargo box would be part #TH93VA.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 10

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 11

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Will 14' Hobie Pro Angler Kayak Fit on Malone MicroSport LowBed 2 Tier Trailer

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching