Picking Out Replacement Actuator for UFP A-60

Question

Question:

need help determining which trailer coupler is good replacement for old A60

asked by: Oliver

0

Expert Reply:

The Dexter DX7.5L A-60 Brake Actuator part # DX89FR for disc or part # DX33FR for drum will work to replace both a UFP A-60 or A-75 Brake Actuator. The A-60 is rated for 6K and the A-75 is rated for 7.5K. The Dexter DX7.5L A-60 Brake Actuator is rated for 7.5K.

expert reply by: Jameson C

0

Answer 1

We definitely have some options available for your 2021 Audi Q8. With your trailer sitting right at 24 inches tall and the hitch sitting at 17 inches, I am going to suggest going with 7 inches of rise. The Curt Ball Mount for 2" Hitches #C45448…

view full answer...

Answer 2

Your 2007 Hummer H3 should have four or five blunt cut wires under the left side of the instrument panel to the left of the steering column. You should see a bundle that contains a red wire with a black stripe, a white wire, light blue wire with a…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...

Answer 8

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 11

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 12

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Picking Out Replacement Actuator for UFP A-60

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching