What Hardware is Needed for Curt Trailer Hitch Mount Spare Tire Carrier # C31006

Question

Question:

I saw that hardware is not included with purchase of this product...what hardware is necessary? What would cost be for the necessary hardware and where can these items be purchased?

asked by: JP

0

Expert Reply:

The hardware in question for the Curt hitch mount spare tire carrier, # C31006, is the nuts and bolts needed to secure the tire to the carrier. If you do not already have some you can acquire them at any local hardware store.

You will also need a hitch pin, # PC3, if you do not already have one. Or, to deter theft, a locking hitch pin like # e98880.

expert reply by: Michael H

0

Answer 1

If you are using the Aluminum Lynx Trailer Wheel part #LHSL311 then your trailer will have 1/2-20" lug studs therefore, in order to secure your spare wheel/tire to the Curt Trailer Hitch Mounted Spare Tire Carrier part #C31006 I recommend using…

view full answer...

Answer 2

Testing lights on your trailer will require a 12V power source so if you are not going to plug in a connector like #H20046 you will need a separate 12V battery. Then use the negative post of the battery to attach your ground wire to and then and use…

view full answer...

Answer 3

Hey Sam, we recommend 1/2 inch grade 8 bolts and nuts for securing your wheel to the Curt spare carrier part #C31006. I wish we sold them but since we do not you'd need to check with a local hardware store.

view full answer...

Answer 4

I do have a solution for you however the Stromberg Carlson Folding Bumper Mounted Tire Carrier #TR-2 will not work with dually wheels. In order to mount your 75 pound Class C tire, I recommend looking into a hitch-mounted carrier like the Curt…

view full answer...

Answer 5

Hey Paul! The short range FastGun Turnbuckles are designed for bed-mounted tie-downs and I would definitely listen to what Kingstar recommends. These are only available in pairs and you will need a pair for the front and rear. You can choose from the…

view full answer...

Answer 6

Good question, Todd! I looked at some pictures we have of the Curt #C37RV hitch installed on a 2024 Hyundai Santa Fe and I think I found a good way to do it. Take a look at the picture I have included and you will see what I am thinking (circled in…

view full answer...

Answer 7

Yes, you will be able to mount your 225/75R16 tire with a 8 lug wheel on the etrailer Hitch Mounted Spare Tire Carrier #e98ZR. I have included an image below with your same size tire and an 8-lug wheel mounted on the carrier.

view full answer...

Answer 8

We do have a potential solution for you. While we do not have any hitch mounted spare tire carriers with a built in swing away feature, we do offer swing away hitch extenders that will work well for this purpose. We recommend using a combination of…

view full answer...

Answer 9

Hello James, thanks for reaching out. The etrailer Spare Tire Mount #e98ZR does not have a specific weight capacity, but it has been known to work with larger tires and wheels. Basically as long as the wheel fits on the carrier, it will be fine to…

view full answer...

Answer 10

Hello again Don; we do have a plug and play wiring harness for your 2010 Honda Odyssey. The Tekonsha T-One Vehicle Wiring Harness #118438 is going to be the most reliable. This will plug into the connection point in your rear cargo area. I went ahead…

view full answer...

What Hardware is Needed for Curt Trailer Hitch Mount Spare Tire Carrier # C31006

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching