Non-Ducted Installation of Air Distribution Box for Advent Air RV Air Conditioners # ACRG15

Question

Question:

Do you just remove the metal part over the vent for non-ducted function?

asked by: Danielle N

0

Expert Reply:

You are correct. You would remove the metal cover on the Air Distribution Box w/ Wall-Mounted Thermostat for Advent Air RV Air Conditioners # ACRG15 when installing in a non-ducted application to allow the air to pass through the vents.

expert reply by: Jameson C

0

Answer 1

Hello Dennis, thanks for reaching out. The Air Distribution Box #ADV48SR will work with any of the 2025 or newer Advent AC units that use the new R32 refrigerant. The part in your picture appears to the Advent ACM135. This part number is an older…

view full answer...

Answer 2

When it comes to roof top air conditioners, the air distribution boxes that are compatible with them are going to be fairly specific. The Advent #ACM135 is compatible with only 2 specific air distribution boxes: the Air Distribution Box and…

view full answer...

Answer 3

Advent Air Conditioners like part #ACM135 come with a connector that pairs up directly with the standard 6-wire connector. If you have a 9-wire connector then you need the kit #ACRG15 as well. For wiring I'm attaching some photos of diagrams for…

view full answer...

Answer 4

If you have the ACTH12 then you should also have the Air Distribution Box #ACRG15 which will have a control box for your wiring from the rooftop unit #ACM135 and the thermostat. This air distribution box and thermostat will wire up exactly the same…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

Hey Neil. The 18,000 Btu Furrion Chill Cube RV Air Conditioner item #LC34DX fits a 14-1/4" x 14-1/4" cutout which is pretty standard on RV's. If you meant to write Dometic instead of domestic then yes it'll fit in your existing…

view full answer...

Answer 12

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Non-Ducted Installation of Air Distribution Box for Advent Air RV Air Conditioners # ACRG15

Continue Researching