Will Installing a Trailer Hitch Void My Warranty on a 2020 Subaru Outback

Question

Question:

Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2 Item # DT94MR Will installing this hitch void my vehicle warranty in any way??

asked by: Joe A

0

Expert Reply:

Installing the Draw-Tite Max-Frame Trailer Hitch Receiver, 2 inch trailer hitch # DT94YR on your 2020 Subaru Outback will not void the warranty.

Consumers are protected under the Magnuson–Moss Warranty Act. It allows aftermarket parts to be installed without warranty issues unless the install or part caused a problem. But the simple act of installing a hitch or other aftermarket part does not void the warranty.

You will want to make sure that the items you are using your hitch for, either for accessories or for towing are within the capacity of the hitch. It is best to abide by the lowest rated component of the system, and in some cases that is the capacity of the vehicle itself.

expert reply by: Rachael H

0

Answer 1

From the center of the hitch pin hole to the front of the receiver on the Draw-Tite Max-Frame Trailer Hitch Receiver #DT94YR measures 2-1/2" while that same measurement to the back of the receiver measures 3-5/8". Keep in mind the back of…

view full answer...

Answer 2

The hitch we offer for your 2022 Subaru Outback Wagon that has the best ground clearance is the Draw Tite part #DT94YR which only has the rear hitch opening below the rear bumper and very close to the rear bumper.

view full answer...

Answer 3

We do have an installation video for the Draw-Tite Max-Frame Trailer Hitch Receiver DT94MR, which was updated to the part #DT94YR, on a 2022 Subaru Outback Wagon that I'm linking for you to check out. It will be located lower on the answer page.…

view full answer...

Answer 4

Hey Adam, so the only hitch size we have for your 2023 Subaru Outback Wagon is a 2 inch like the Draw Tite part #DT94YR but we can still help. What you'd want is the Draw Tite hitch and then a hitch reducer like the part #e63YR and you'd be…

view full answer...

Answer 5

The most hidden hitch I would recommend for your 2022 Subaru Outback Wagon is the Draw Tite part #DT94YR which will only have the lower hitch opening below the rear bumper. This gives the most hidden look and also helps with ground clearance. I…

view full answer...

Answer 6

For your 2021 Subaru Outback Wagon I recommend the Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2" #DT94YR as it has the most ground clearance out of all of the hitches available for your vehicle at 16" as you can…

view full answer...

Answer 7

Yes, you will have to remove the bumper on your 2023 Subaru Outback Wagon to install the Draw-Tite Max-Frame Trailer Hitch Receiver #DT94YR. It can be a bit daunting especially if you've never done anything like this before but there aren't…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

Hey Ricardo! Yes, the Curt Trailer Hitch Receiver #C82RJ is the hitch Curt is working on for the new 2027 Telluride. This is a pre-order since Curt hasn't finished the design. It does not include wiring. The wiring harness for the 2027 is also up…

view full answer...

Answer 12

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Will Installing a Trailer Hitch Void My Warranty on a 2020 Subaru Outback

Continue Researching