Recommended Landing Gear Set for 2007 Rockwood Signature Ultralight

Question

Question:

need landing gear set up for a 2007 Rockwood Signature Ultralight. What product that you sell will fit.

asked by: Frank S

0

Expert Reply:

The landing gear legs for most fifth wheel trailers are fairly standard. The standard ones measures 29-1/2" long with weld stops 15-1/2" apart (inside to inside). If this is what you have, the Lippert Electric Landing Gear Set part # LC333964 will be a direct bolt-on fit.

expert reply by: Conner L

0

Answer 1

Unfortunately we do not have a parts breakdown for your Everchill refrigerator #324-000119. I did some research for you and it does sound like you have a thermistor that is defective. That is normally the issue when the freezer is cold but the…

view full answer...

Answer 2

Since the lights and fan in your Everchill WD-282FWDC Refrigerator #324-000119 work but the compressor does not appear to be performing its cooling duties I suspect you may have a power issue. The compressor will not operate unless it sees at least…

view full answer...

Answer 3

For your Everchill RV Refrigerator w/ Freezer #324-000119 I believe they're referring to the thermal fuses which are internal to the refrigerator and won't be on the fuse panel with the rest of the fuses. If you refer to the rear of your…

view full answer...

Answer 4

There could be a number of causes as to why your Everchill RV Refrigerator w/ Freezer #324-000119 is malfunctioning. I would start by removing the fuse to fully cut the power and waiting a few minutes for the unit to fully reset. If resetting the…

view full answer...

Answer 5

I would be happy to help you. I don't have any way of knowing what type of landing gear you have on your 2010 Forrest River 5th Wheel to possibly find a matching replacement leg. Since you are ok replacing both front legs and have weld stops at…

view full answer...

Answer 6

The correct replacement motor is part #LG-142178, and the Replacement Aluminum Gearbox, #LG-179015. The correct replacement switch is the part #LG-145236.

view full answer...

Answer 7

So the reason landing gear is blowing fuses is because of an overdraw on the circuit. This can often happen with a bad gearbox causing the motor to work too hard, so you did the right thing in replacing it with the #LC276602. The wiring is the next…

view full answer...

Answer 8

You might be able to get something like a center punch and tap it as much as possible at an angle. That could drive enough of it out the other side to be able to grab it with some pliers or vice grips. Another possible method would be to get a…

view full answer...

Answer 9

Thanks for all that good info, and what you have is the Ultra-Fab Deluxe Electric Landing Gear Set #UF17-943010, which you can replace with a Lippert set with a high speed motor on you RV, though you will need to have new brackets welded on. The…

view full answer...

Answer 10

Given the issue you described and the fact that you have done a good job of troubleshooting and checking other potential sources for the issue, it sounds like the motor is going bad. Since you mentioned the landing gear working fine for a little bit…

view full answer...

Answer 11

It is possible that there is a part number somewhere that would help identify the landing gear on your trailer. Sometimes there is information on the underside of the caps on the tops of the jacks so that is another place you can check if you…

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Recommended Landing Gear Set for 2007 Rockwood Signature Ultralight

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching