Replacement Hub Seals for Dexter 12,000 lb Axle

Question

Question:

I’m looking for all seals for dexter 12000 pound axle it has the 7 bolt pattern on the backing plate if that helps

asked by: Shane

0

Expert Reply:

For your Dexter 12,000 lb axle the seal you are looking for based on my research is the # 10-56. It has an inner diameter of 3.125 inches and an outer diameter of 4.5 inches. This will work well for oil or grease.

If you are needing the other seal for an oil bath, you would also want the Replacement Oil Cap Kit for 9,000-lb to 15,000-lb Dexter Axle # RG04-270 which comes with the cap, o-ring, and rubber plug.

expert reply by: Jason S

0

Answer 1

Thank you so much for that information, and we can get you everything you need to convert to a disc brake set up for your 10k Dexter axles. While there isn't a single kit, we do have all of the parts you need, and let's start with the brake…

view full answer...

Answer 2

Hello Greg, thanks for reaching out. The Dexter Electric Trailer Brake Assembly #23-443 uses an industry standard 7-bolt pattern. I have included a picture that shows the bolt pattern dimensions for you below. These are all measured center hole to…

view full answer...

Answer 3

Dexter Axle has the brand recognition so that will definitely weigh more in their favor. Axle Technology isn't as well known even though their parts are very common on trailers but they're mostly used buy trailer manufacturers. So their parts…

view full answer...

Answer 4

For 12,000 lb Dexter axles we do have the correct brake assembly replacements with the part #23-442 for the left hand side or the part #23-443 for the right hand side.

view full answer...

Answer 5

The factory brake controller connector on your 2021 Jeep Grand Cherokee is located under the dash behind the hood latch, as shown in the provided photo. Keep in mind, the connector will only be there if the vehicle has the factory tow package which…

view full answer...

Answer 6

Yes we do, the correct oil seal you would need is the part #10-56 which I verified has same dimensions as the 295924 that you have now.

view full answer...

Answer 7

Hi Robert! The 17-1/2" wheels are a bit more limited than other offerings, but I think you may be interested in the following two options: Americana Hub-Piloted Solid Center Wheel w -0.5" Offset - 17-1/2" x 6-3/4" - 8 on 6-1/2 -…

view full answer...

Answer 8

Hey Ron! Sorry to hear that happened. Have you asked them to replace it? The Mighty Cord Replacement RV Power Inlet #A10-30INBKVP door isn't available separately but it can be replaced. You can remove the four screws from the cover which will…

view full answer...

Answer 9

I'm not sure why they said those were your only options, but we do have the correct replacement oil seal for your Dexter 10k hub from 2006, and is the exact replacement for a National 370150BG: - Unitized Oil Seal #10-51 The #10-51 has an inner…

view full answer...

Answer 10

I spoke to Dexter and they said there is a bit of a process for installing the spindle nut properly. 1. You will need to thread on the inner nut, rotate the hub, then tighten the nut to 100 foot pounds. 2. Loosen the nut to remove the torque, making…

view full answer...

Answer 11

Typically for installing oil bath hub seals you can set a wood block across it and use a hammer to push it in evenly. For a Dexter 12k axle the correct seal would be the part #10-56.

view full answer...