Will AirLift Air Bags Work With B&W Turnoverball Hitch On a 2019 GMC Sierra 2500

Question

Question:

Any interference with the installation of the 5000 bags on a 2019 GMC 2500 that I will be installing the BW BWGNRK1016 Thank you

asked by: Samuel L

0

Expert Reply:

Yes, the Air Lift LoadLifter 5000 Air Helper Springs part # AL57338 will work with the B&W Turnoverball Underbed Gooseneck Trailer Hitch part # BWGNRK1016 on a 2019 GMC Sierra 2500. The hitch installs on the outside of the frame rails and the air bags install on the bottom of the frame so there will be no compatibility issues.

I also recommend adding an on-board air compressor to easily fill and deflate the airbags when needed, the Air Lift WirelessONE Compressor System part # AL25980EZ is an all-in-one system therefore easy to install and is wireless therefore no air lines or wires must be run into the cab of the vehicle.

expert reply by: Conner L

0

Answer 1

The correct B&W Turnoverball Underbed Gooseneck Trailer Hitch for a 2013 Chevrolet Silverado 3500HD is part #BWGNRK1012. In regards to the Air Lift LoadLifter 5000 Air Helper Springs part #AL57338, you can use these with the B&W Turnoverball…

view full answer...

Answer 2

Sounds like you have the Air Lift Kit part #AL57338 installed in your 2011 Chevy Silverado. If you check out the picture I attached you will see that when using this kit on a vehicle with fifth wheel/gooseneck rails you would not use the included…

view full answer...

Answer 3

Hello Matthew, The #AL57595 you were looking at is for the Ram trucks. For your 2016 Sierra 2500HD we do not have the Air Lift 7500's, we do have the Firestone Red Label with a 7,500 load leveling capacity #F2709 which will work great with the…

view full answer...

Answer 4

The Air Lift LoadLifter part #AL57338 for the 2018 Chevy Silverado 2500 will require drilling if you have the B&W Gooseneck hitch but it will be compatible. The self tapping screws will allow you to attach the Air Lift springs to the bottom of…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

Hey Jordan! Based on your measurement you have a Lippert 1116 or 1716. If you want to confirm that feel free to send me the S/N on your pin box. The Gen-Y Nomad you were looking at is for the Rhino Box so that is not a fit. What you need is the Gen-Y…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Will AirLift Air Bags Work With B&W Turnoverball Hitch On a 2019 GMC Sierra 2500

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching