Replacement for Airxcel Coleman Mach 8000 Series Air Conditioner

Question

Question:

Can this unit be used to replace an Airxcel 8000 series ducted unit with an analog thermostat?

asked by: Larry F

1

Helpful Expert Reply:

The correct replacement overhead unit for an Airxcel 8000 Series Air Conditioner which is made by Coleman Mach is the Advent Air Replacement RV Air Conditioner for Coleman Setup w/ Start Capacitor part # ACCOL150. There won't be any issues reusing your existing thermostat.

expert reply by: Conner L

1

Answer 1

Well there are two routes you can take when replacing the AC unit: Route 1: You replace just the rooftop (condenser) unit and keep the same air distribution box and thermostat. Route 2: You replace the entire system (condenser unit, air distribution…

view full answer...

Answer 2

Based on the part number you mentioned that would indicate you have a Coleman Mach RV AC unit so for a direct replacement AC unit solution you would want the Advent Air unit part #ACM135B that you mentioned as well as the Coleman adapter kit part…

view full answer...

Answer 3

Your best option to replace the Coleman AC unit in your 2000 Tiffin Allegro is with the Advent Air #ACM150 along with the Coleman Adapter Kit #ACCOLKIT. This wiring adapter kit should allow for a plug-and-play installation when replacing the unit. I…

view full answer...

Answer 4

The Advent Air Replacement RV Air Conditioner #ACDOM150B has a 76 decibel level, which is comparable to a vacuum cleaner. Before purchasing replacements you'll want to check if your current unit has a 6-pin or 9-pin wire harness connector. If…

view full answer...

Answer 5

The RVP 8000 series AC model 8333A871 is effectively a Coleman Mach air conditioner, as RVP is the parent company and owner of the Coleman AC line of products; this means they will have the same wiring connections as a Coleman unit. To replace an…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

Hello Sam; that is a great question! I reached out to Furrion and you will be able to use the Furrion Chill Cube #FR69TD (white) or #FR49TD (black) with your furnace. However, the remote is not capable of operating the furnace at this time. Also, we…

view full answer...

Answer 8

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 9

The best replacement option we offer for a Atwood GC10A-4E Water Heater is tankless, the Furrion RV Tankless Water Heater part #FR68SR. It won't be a direct replacement but still pretty easy nonetheless as they are very similar. That said, you…

view full answer...

Answer 10

Hey Matt, Furrion typically has 4 wires running to their thermostats and the Chill Cube Thermostat #LC74DX is no exception. The harness you see with the thermostat would plug into the Chill Cube's controller and has 4 wires to extra wire to to…

view full answer...

Answer 11

Hey Neil. The 18,000 Btu Furrion Chill Cube RV Air Conditioner item #LC34DX fits a 14-1/4" x 14-1/4" cutout which is pretty standard on RV's. If you meant to write Dometic instead of domestic then yes it'll fit in your existing…

view full answer...

Answer 12

Hi JD; the Furrion Chill Cube #FR49TD air distribution box has a vent on it you can open and close. See the picture attached below. When it is closed it forces more of the air through the ducted system. Assuming you have a ducted system you will need…

view full answer...

Replacement for Airxcel Coleman Mach 8000 Series Air Conditioner

Continue Researching