Replacement Handle For Extreme Off-Road Swing-Up Trailer Jack w/ Dual Wheels

Question

Question:

I have the Ark extreme swing up jack is there a replacement handle available?

asked by: Lew

0

Expert Reply:

There is a replacement handle for the Extreme Off-Road Swing-Up Trailer Jack w/ Dual Wheels part # ORJW750D with Replacement Jack Handle for Extreme Off-Road Trailer Jack part # ORJW750SH.

expert reply by: Heather A

0

Answer 1

We have the Replacement Jack Handle #ORJW750SH which will fit your Xtreme Off-Road Swing-Up Trailer Jack #ORJW750BD. This handle has a zinc finish as opposed to the black finish on your jack.

view full answer...

Answer 2

Hey Keith, actually there isn't any difference between the two part numbers. Our part number is the part #ARK57FR but we also carry it as the manufacturer part number #ORJW750D for some reason. I'd say order whichever has the better price but…

view full answer...

Answer 3

Hey David, the correct replacement handle for your Ark Xtreme Off-Road Trailer Swivel Jack w/ 2 Wheels #ORJW750D is the Replacement Jack Handle for Ark Xtreme Off-Road Trailer Jack #ORJW750SH.

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Replacement Handle For Extreme Off-Road Swing-Up Trailer Jack w/ Dual Wheels

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching