Breaking Down the Ark Xtreme Off-Road Tube Mount Swivel Trailer Jack- Sidewind Video

The mounting plate on the ARK Removable Extreme Off-Road Swing-Up Trailer Jack #ARK57FR is 5-1/2" wide and 7-1/2" tall. It is designed with several bolt hole patterns(see image) to fit trailer tongues from 2-6" tall.

The only solution we offer for a removable trailer jack is the ARK part #ARK57FR that you referenced Jerry. The removable feature isn't a super high demand option so there aren't a whole lot of jacks with that feature built in.

With the ARK Xtreme Off-Road Swing-Up Jack #ORJW500D in its lowest position it is 6.49" from the center of the mounting point to the top of the jack. The other end of the jack when fully retracted is going to be 18.89" from the…

The ARK trailer jack part #ARK57FR uses a dual wheel setup with rubber tires that were designed for getting over off-road terrain which will be much easier to move by hand but the easiest would be the Trailer Valet 5X part #STC-V211 which comes…

I have attached two diagrams below with the dimensions for the XO350 and XO750. Both of these use a bolt on installation so you really only need to know the height of your tongue to see if it is compatible. The #ORJW350D fits 2" to…

When fully retracted, or collapsed the jack is 28.58 inches tall, and 38.42 inches tall when extended as shown in the provided diagram. I've linked you to a product description video featuring the #ORJW1SU ARK Extreme Off-Road Ratcheting…

A typical tire inflator will have a CFM rating of around 1.5 to 2 CFM, with a majority of the little cheap ones being less than 1 CFM. The higher the rating the faster you'll be able to air up the tires. The Viair Automatic Portable Air…

Yes, the Extreme Off-Road Swing-Up Jack w/ Dual Wheels iItem #ORJW500D will work for your T@B 400 Tear Drop Trailer. It looks like your trailer comes with an a-frame jack. You would need to ensure you have enough space on your tongue to accommodate…

Each of the Furrion tankless water heaters measure 12-5/8" wide x 12-5/8" tall x 19-1/4" deep, so that is the size the compartment needs to be. As for the door, there may be trimming needed, depending on the size of the door you have…

We do have a potential solution for you, but I will tell you up front that we do not offer a direct replacement for your Direct Vent Water Heater Model SW6D. What we recommend as a replacement is the Furrion RV Tankless Water Heater #FR98SR. This…

I would be happy to help you with those measurements for the Ark Removable Extreme Off-Road Swing-Up Trailer Jack item #ARK57FR. It is a standard fitting so unless your trailer has something custom added to it, it should fit. The Ark jack will fit a…

I attached a picture that has the measurements of the mounting holes on the mounting plate of the Dutton Lainson Sidewind jack #DL22339 that you referenced. Basically they are 5-1/2 inches from left to right and then 2-3/8 top to bottom row and then…