Flat Towing Package for 2020 Jeep Wrangler JL Rubicon Unlimited

Published 11/20/2019

Products Featured in This Question

Demco Commander II Non-Binding Tow Bar - RV Mount - 2" Hitch - 6,000 lbs

(84)

$879.00

Demco Tabless Base Plate Kit - Removable Arms

(412)

$491.18

Roadmaster 4-Diode Universal Wiring Kit for Towed Vehicles - 7-Way to 6-Way Coiled Adapter Cord

(3397)

$161.90

Roadmaster Brake-Lite Relay Kit for Towed Vehicles

(737)

$48.10

Roadmaster Even Brake Portable Flat Tow Brake System - Proportional

(57)

$1930.00

Question:

Can you tell me what parts I need to tow my 2020 Jeep Wrangler JL Rubicon Unlimited behind my class A? Thank you in advance!

asked by: Trenton

Expert Reply:

There are 5 main components that are needed to safely flat tow your vehicle:

Tow bar - link between your RV and your Jeep
Base plate kit - custom made to install on the frond end of your Jeep - provides connection point for tow bar
Safety cable set - keeps your Jeep connected to your RV in the rare event that your set up is somehow uncoupled
Tow bar wiring - allows your Jeep's tail lights work in sync with your RV's tail lights
Supplemental braking system - allows your Jeep's brakes to work in sync with your RV's brakes

Below I'll explain my recommendations for each:

Demco Tabless Base Plate Kit # DM9519336 (compatible with either plastic or steel factory bumper) - It features removable bracket arms, which provide a clean, unobtrusive look when your car is not being towed. I attached a photo on a 2018 JL (same generation) for reference.

Demco Commander II Tow Bar # DM9511012 - The arms are telescoping for easier hook-up and non-binding for minimal effort when unhooking even on unlevel ground. Bonus: the safety cables are included!

Roadmaster Diode Wiring Kit # RM-15267 - Most reliable wiring kit for your Jeep prevents electrical feedback and the damage it can cause to your vehicle's electrical components. A 7-wire to 6-wire coiled electrical cord is included to connect to your RV plug.

Roadmaster Even Brake Supplemental Braking System # RM-9400 - This system is one of my favorites because it's portable (fit's most vehicles) and easy to use. It's proportional which means the brakes on your Jeep are activated at the same time and with the same intensity as those in your RV.

You'll also need a brake light relay # RM-88400 as without it, the brake signal from your towed car will override the turn signal sent by your RV when you slow down to make turns, creating a potential hazard.

You will likely also need a high-low adapter to make up for the height difference between your RV and your Jeep. Once installed, the Demco base plates will have a bracket height of 18 inches (from the ground). To calculate the amount of drop needed, measure your RV's hitch height (ground to top of receiver opening) and deduct the 18 inches from it. I'll attach a link to our available selection of high-low adapters for you to browse through along with a couple helpful articles.