Recommended Camera System for Pre-Wired 2020 Winnebago Minnie Plus

Question

Question:

I am picking up 2020 Winnebago Minnie plus TT 30RLSS tomorrow. It is prewired for a camera and I need assistance on the best option for me.

asked by: Monique H

1

Helpful Expert Reply:

Your 2020 Winnebago Minnie is pre-wired for a Voyager Camera System and I specifically recommend the Voyager WiSight Wireless RV Backup Camera # ASA37YR.

expert reply by: Chris R

1

Answer 1

Hi Kirk, The Voyager PWM Filter for Voyager RV Camera System part #VGR74VR doesn't install into your vehicle or RV's 7-way. This connector needs to be installed between the factory Voyager camera wiring and the camera itself. You can do this…

view full answer...

Answer 2

Hello Gary, It sounds like you’ve already done most of the right troubleshooting, so you’re definitely on the right track. With the Voyager WiSight 2.0 system #ASA37YR, the most common issue when it won’t pair is actually power at the camera, not the…

view full answer...

Answer 3

Hey Walter. The Voyager WiSight 2.0 Wireless Backup Camera System item #ASA37YR is only going to work if your Forest River is prewired for a Voyager system. Trailer's with this kind of pre-wiring will be specifically marked. I have attached a…

view full answer...

Answer 4

The steps for pairing your Voyager WiSight 2.0 Wireless Backup Camera System #ASA37YR camera and monitor are as follows: 1. Make sure the monitor is connected to 12 Volt DC power supply, but 12 Volt DC power is removed from the camera (clearance…

view full answer...

Answer 5

Since your current camera only says Voyager that means it is going to be the 1st generation. The WiSight 2.0 Camera #ASA74YR has Voyager 2.0 on the camera. So you are going want a new system with either the 4.3" Monitor #ASA24YR or 7"…

view full answer...

Answer 6

We do have what you need, but since your 2022 Winnebago 2529RG is prewired for the Voyager system you will not want to use the Voyager WiSight 2.0 Wireless RV Backup Camera System w/ Night Vision #ASA57YR that you were looking at. Because you will…

view full answer...

Answer 7

You are going to be able to use either the original Voyager WiSight or the WiSight 2.0 with the Voyager Prep on your 2022 Winnebago Micro Minnie 1700BH. The prep is simply the electrical connection and the specific mounting pattern for the screws on…

view full answer...

Answer 8

The Coachmen Apex Ultra Lite is pre-wired for the Voyager WiSight 2.0 Wireless Backup Camera System, part #ASA24YR for a 4.3" monitor or part #ASA37YR for a 7" monitor. This is the only system which will plug into the rear camera port…

view full answer...

Answer 9

Hey Randy! That is correct. The 12V PWM Filter for RV Backup Camera Systems #VGR64VR is a permanent solution to the PWM problem with cameras and modern trucks. This installs on the camera wiring so you don't have to carry around an adapter like…

view full answer...

Answer 10

For additional rear facing style cameras to use with the Voyager Wisight part #ASA37YR that you plan to install on your 2021 Winnebago Minnie you'd want the Replacement camera part #ASA74YR which you could use in any of the locations you…

view full answer...

Answer 11

Basically I was referring to the width of the goosneck trailer nose. So measure the width of the trailer at the very front. This is the formula you referenced though. To determine if you can safely make tight turns, there is a formula you can follow.…

view full answer...

Answer 12

Sounds like you are looking for the formula for determining if you have enough clearance to make 90 degree turns with a fifth wheel trailer hitched up to a truck. The formula you are referring to is this: (A + B) - C = Clearance A = Distance from the…

view full answer...

Recommended Camera System for Pre-Wired 2020 Winnebago Minnie Plus

Product Page this Question was Asked From

Continue Researching