Plug-In Harness for the Tekonsha Prodigy P3 On a 2013 Ram

Question

Question:

Does this controller have the plug-n-play wiring harness for my 2013 dodge ram

asked by: Michael Y

0

Expert Reply:

Yes, the Tekonsha Custom Wiring Adapter for Trailer Brake Controllers part # 3023-P is what you need to install the Tekonsha Prodigy P3 Trailer Brake Controller part # 90195 on a 2013 Ram. I have attached a video for you that shows where the port will be located.

expert reply by: Conner L

0

Answer 1

There are absolutely plug-in wiring adapters for a brake controller for your 2020 Ram 1500, and what you can use is the Curt Custom Wiring Adapter for Trailer Brake Controllers - Dual Plug In #C51458 Then for a brake controller that doesn't take…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 7

You're right, the mounting bracket is unique (in a good way) for the Curt TriFlex NEXT Trailer Brake Controller #C24VV. The bracket is smaller and all you do is put the included adhesive tape on the bracket and stick it wherever you like under…

view full answer...

Answer 8

Hi there Chris, great question. Yes the Redarc #RED87CR is truly a plug and play brake controller for your 2026 Ram 1500. It connects directly to the factory tow controller connector under the dash, so there’s no dealer programming required like you…

view full answer...

Answer 9

Hey Brandon, I would strongly recommend sticking with the Tekonsha RF brake controller part #TK94FR. We know this works really well and it sounds like it worked well for you too. The Curt Echo is not reliable enough for me to really ever recommend it…

view full answer...

Answer 10

We can get you everything you need for towing with your 2017 Toyota Sienna XLE. By plastic shield, I believe you are referring to the appearance panel underneath the Sienna, and that will have to trimmed a bit in each of the hitches available for the…

view full answer...

Plug-In Harness for the Tekonsha Prodigy P3 On a 2013 Ram

Featured Help Information

Miscellaneous Media

Continue Researching