How To Replace the Light In etrailer.com Ram Electric Jack

Question

Question:

How do I replace the light on the jack?

asked by: Anthony D

0

Expert Reply:

You can replace the light on the Electric Jack w/ Footplate - A-Frame - 25-1/8" Lift - 3.5K - Black part # EJ-3520-BBX with Replacement Light Board for etrailer Electric Jack part # EJ-3520-LT all you would need to do is remove the jack cover and look at how the existing light board is wired. Remove that one and replace it.

If the cover needs to be replaced, I recommend Replacement Cover for etrailer and Ram Electric A-Frame Jacks part # EJ-3520-BCV.

expert reply by: Heather A

0

Answer 1

You can absolutely change out the lock cores on the now-discontinued Thule Force XL 625 or the Thule Force XT XL Rooftop Cargo Box #TH6358B. You will need new lock cores and the Thule One-Key System Lock Cylinders #TH450200 will do the trick. It…

view full answer...

Answer 2

I am attaching a picture of the Replacement Power Switch #EJ-3520-PSW when it is properly installed on the Electric Jack w/ Footplate #EJ-3520-BBX but unfortunately there isn't a wiring diagram available. If you be mindful to note which position…

view full answer...

Answer 3

Hi Tom, I have two options to replace the electric tongue jack on your Jayco Whitehawk: Option 1: Electric Jack w/ Footplate #EJ-3520-BBX. This jack is going to be your no-frills 'get the job done' style jack. It has a 3,500lb capacity and…

view full answer...

Answer 4

Hey Mark, the height of the etrailer Electric Trailer Jack #e23ZV that you referenced above the mounting plate is 20 inches. This is about the shortest dimension you'll get from a jack like this. Would that be enough clearance?

view full answer...

Answer 5

Electric tongue jacks like the Electric Jack w/ Footplate - A-Frame - 25-1/8" Lift - 3.5K - Black #EJ-3520-BBX are designed to use a 12v power so if you want constant power I recommend using a trailer battery for connection. If you only want…

view full answer...

Answer 6

Hello Ralph, thanks for reaching out. The etrailer Electric Trailer Jack #e23ZV will be a great option for you. The jack can be rotated to the side if needed. We have one of these jacks on our trailer here at the shop and I have seen it rotated and…

view full answer...

Answer 7

I recommend replacing your jack with our Electric Jack #EJ-3520-BBX. This is a simple jack without the bells and whistles like you are looking for. You get a light, electric jack and manual override should the electric motor die. The jack will bolt…

view full answer...

Answer 8

Hey Chris! The black wire on the etrailer Electric Trailer Jack #e23ZV is just a ground wire. Realistically you can ground it however you want but I would say running it to the frame with a self-tapping screw as indicated in the instructions is the…

view full answer...

How To Replace the Light In etrailer.com Ram Electric Jack

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching