Vent Cover For MaxxFan Roof Vent 4301K

Question

Question:

I have a Maxxfan 4301K, which cover will fit? It has 4 mounting tabs

asked by: Doug

1

Helpful Expert Reply:

This cover will fit. The MaxxAir FanMate RV and Trailer Roof Vent Cover # MA00-955001 is designed to fit all of the 4000 Series MaxxAir Fans with 4 mounting tabs, including your MaxxFan Roof Vent w/ 12V Fan 4301K # MA00A04301K

expert reply by: Erik B

1

Answer 1

Each of the replacement ladders that we carry are universal fits as we don't carry OEM replacement parts, just aftermarket parts. These ladders will work for your 2017 Grand Design Solitude 310GK but will require installation and they can be cut…

view full answer...

Answer 2

The Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger #PD4560K18LS8 that you reference will work fine as a replacement for your American/Centurion CS6000 Converter. Since there isn't any direct replacements…

view full answer...

Answer 3

The best place to confirm the towing capacity of your 2015 Chevy Silverado 1500 Crew Cab 4x4 with 5.3-liter V8 engine is the printed owner's manual. This will reflect the capacity of your specific pickup with the particular mix of equipment…

view full answer...

Answer 4

The Trailer Valet part #STC-V211 that you referenced can be installed on either the left or right hand side of a trailer. I attached a picture of it mounted to the left side of a trailer for you to check out as well.

view full answer...

Answer 5

If you don't see any bolts holding the existing jack onto the trailer frame, it might have been installed by welding it in place. If this is the case, you'd need to grind off the welds, which is something you'd probably need a…

view full answer...

Answer 6

Hi Shawn! You're dealing with a common issue when installing a MaxxAir II cover #MA76JR on a MaxxFan 4751KS, like the #MA00-04751KSX. Here’s the situation you're running into: -First, the MaxxFan lid opens almost vertical when fully opened…

view full answer...

Answer 7

The tallest roof vent cover we offer in white is going to be the MaxxAir FanMate RV and Trailer Roof Vent Cover part #MA00-955001 which is about 10-1/4" at its highest point. I will say that most of the auto-open roof vents will stop raising…

view full answer...

Answer 8

Hey Alexandria! Bike racks rated for travel trailers are pretty limited. There is quite a bit of additional force back there. This also means there are no 1-1/4" bike racks that will work. I have two different options for you. The first is to…

view full answer...

Answer 9

Hey Larry! We don't have any covers available designed for the Ventline mounting points. However, you can still use other covers with your vent since they're all designed to fit a standard 14" x 14" trailer vent. I recommend using…

view full answer...

Answer 10

Hey Liz. The cameras of the Furrion Vision S+ item #FR64AD will need to be wired directly to a constant 12v power source, like your Grand Design's batteries, to use them in the security mode. With the infrared lights on each camera will pull less…

view full answer...

Answer 11

Hey, Kenny! The gasket included in the Steel Rubber RV air conditioner rubber gasket kit, part #SR73MR, is 1" tall and 1-1/2" wide. It’s designed to fit the standard 14" x 14" AC opening. Below, you’ll see a picture showing all of…

view full answer...

Answer 12

Hey Mike! The Soft Start Kit for Coleman-Mach RV Air Conditioners #CM56RR is designed to work with 45000, 47000, and 48000 air conditioners. Based on those numbers I'm assuming you those are 38000 series, but the model number doesn't always…

view full answer...

Vent Cover For MaxxFan Roof Vent 4301K

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching