Will The Blue Ox Clamp-On Lift Brackets Fit Both 4" and 6" Channel Frame Rails

Question

Question:

Will these clamp on 4" channel, and 6" channel frame rails?

asked by: Jim S

1

Helpful Expert Reply:

I reached out to Blue Ox on your behalf who confirmed that the Clamp-On Lift Brackets for Blue Ox SwayPro Weight Distribution Systems # BXW4010 will fit both 4" and 6" channel frame rails.

Included below are a couple of video resources for additional information.

expert reply by: Patrick R

1

Answer 1

Your situation is a great option for the Blue Ox SwayPro Weight Distribution #BLU54TR. This particular kit is rated for trailers up to 15,000lbs with a tongue weight of 1,000-1,500lbs. When you need to haul your travel trailer you can use some…

view full answer...

Answer 2

Hey Ralph, welcome back! If there's any gap when you install the Clamp-On Lift Brackets item #BXW4010 it should be on the inside of the trailer tongue as shown in the picture below. If this doesn't answer your question go ahead and email me a…

view full answer...

Answer 3

A 13,500 btu air conditioner normally draws right at 1,300 watts which the solar panel kit part #34282184 can only provide up to 380 watts at peak performance. The highest wattage setup we have from solar panels is the #34282185 which is capable of…

view full answer...

Answer 4

Hey Robert. What specific information are you looking for on the GE Appliances RV Washer/Condenser Dryer Combo item #GE62FR? The GE Appliances RV Washer/Condenser Dryer Combo item #GE62FR runs off of a standard 120V outlet. It's pretty small and…

view full answer...

Answer 5

I prefer the LoadLifter 5000 setups over the style that install in the coil of the vehicle like what fits your 2017 Ram 1500. So I would recommend the #AL88365. The LoadLifter style of bag can offer better support and since it wouldn't be rubbing…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 10

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 11

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 12

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Will The Blue Ox Clamp-On Lift Brackets Fit Both 4" and 6" Channel Frame Rails

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching