Lock Cylinders and Keys for Thule Evo Raised Rail Roof Rack Feet

Question

Question:

Do you have locksets for Thule evo raised rail roof rack feet?

asked by: Mike L

0

Expert Reply:

Yes we do! You can use the Thule One-Key System Lock Cylinders # TH450400 for your Evo Raised Rail Feet # TH710401. This comes with 4 cylinders, 2 keys, and one universal change key for the installation.

I have attached a review video for you to check out.

expert reply by: Jon G

0

Answer 1

Yes, that should not be a problem at all. The Thule Hullavator Pro Kayak Carrier and Lift Assist with Tie-Downs - Side Loading, part #TH898, does not interfere with how your crossbars attach to the the roof of your vehicle. I would just advise you to…

view full answer...

Answer 2

You can definitely fit the Thule Force XT XL #TH6358B on your 2019 Toyota 4Runner with enough hatch clearance, but you'll need to install an aftermarket roof rack to accomplish this because the OEM roof rack on your 4Runner sits too close to the…

view full answer...

Answer 3

We do have a fit for a Thule roof rack for your 2021 Toyota 4Runner, so long as it has raised side rails on the roof. If so, you would actually only need two parts in order to install the rack - the crossbars and feet. The parts that fit your '21…

view full answer...

Answer 4

For the Thule Hullavator Pro #TH898 to properly fit on your 2015 Toyota RAV4 your crossbars will simply need to extend 4-8 inches beyond the feet of the roof rack. If your RAV4 has the raised side rails then the best option for you to go with would…

view full answer...

Answer 5

In order to use the Thule Hullavator part #TH898 on your 2015 Toyota RAV4, I recommend using the Malone AirFlow2 Roof Rack part #MPG216. These crossbars will attach to the factory side rails on your RAV4 and allow you to use your Hullavator without…

view full answer...

Answer 6

Hi Mary; the Thule Hullavator #TH898 requires crossbars that extend 4" - 8" beyond the feet of the roof rack. Unless the 2024 Toyota RAV4 factory roof rack meets this requirement (I doubt it does) you're looking at an aftermarket roof…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 11

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 12

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Lock Cylinders and Keys for Thule Evo Raised Rail Roof Rack Feet

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching