Does Replacement U-Bolt Fit All Blue Ox SwayPro Weight Distribution Systems

Question

Question:

Does the same u bolts fit all sway pro bars?

asked by: Horace

0

Expert Reply:

Yes, the Replacement U-Bolt # BX201-0758 is the same for all of the Blue Ox SwayPro weight distribution (WD) systems. We also carry the flat washer # BX203-0003 and the nylon nut # BX202-0090 needed to install this U-Bolt.

Just for reference this U-Bolt measures 2" long x 1-3/8" wide and has a 5/16" diameter.

expert reply by: Jon G

0

Answer 1

Hey Rick, yes you can just swap out the shank that you have now for one that is designed for a 2-1/2 inch hitch like the Blue Ox part #BXW4028. You probably already know this but you'll most likely need different spring bar tension on the new…

view full answer...

Answer 2

It does seem like the hardware would come with what you ordered but unfortunately it is sold as a separate item. There is not a hardware kit from blue ox specifically for the SwayPro hitch. What you will need is pair each of Grade 5 zinc-plated…

view full answer...

Answer 3

There is not necessarily a specific lifespan that can be counted on with hitch lock like your Blue Ox Trailer Hitch Receiver Lock for 2" Hitches #BX8858. If it gets used heavily and a lot of stress on it then a lock can wear down quicker than…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 10

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 11

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Does Replacement U-Bolt Fit All Blue Ox SwayPro Weight Distribution Systems

Products Featured in This Question

Continue Researching