Is the Advent Air Replacement RV Air Conditioner for Dometic Setup a "Vent"

Question

Question:

.

asked by: Jerry

0

Expert Reply:

The Advent Air Replacement RV Air Conditioner for Dometic Setup # ACDOM150 moves cooled air through vents present on an RV. I believe I found where Chris R (in a different answer) referred to this assembly as a vent. Probably not the most accurate word to use for the AC unit but he was referring to the entire # ACDOM150. As long as you have a Dometic kit installed on your RV currently this will fit and replace it with minimal install time.

expert reply by: Jameson C

0

Jerry

6/25/2019

.

Jameson C.

6/25/2019

.

Answer 1

For your Dometic DuoTherm the Advent Air Unit part #ACDOM150 would be your best option that will give you the higher BTU rating 15k and easily connects to the current wiring you have now.

view full answer...

Answer 2

Hey Bob, you'll want to go with the Furrion Chill HE Replacement RV Air Conditioner for Coleman Setup - 15,000 Btu - White #FR42PV. This is specifically for Coleman, Dometic, or Advent distribution systems.

view full answer...

Answer 3

Hey there Ross; thanks for that info and your 15,000 Btu Dometic Brisk Air II AC can absolutely be replaced by an Advent unit. I do recommend going with the low-profile option as not only does it look better, but the less height you can add on top of…

view full answer...

Answer 4

The Advent Air RV AC unit part #ACDOM135 is actually very similar to the Dometic Duo Therm to the point many would say it's a little too close of a copy...that said it does work really well and would be a solid option to replace your Penguin…

view full answer...

Answer 5

In general you get about 10 percent additional cooling power going from a 13k BTU AC unit to a 15K and most will report that the additional cooling power comes in handy. The price difference typically isn't that much but if you go with a smaller…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

Hey Neil. The 18,000 Btu Furrion Chill Cube RV Air Conditioner item #LC34DX fits a 14-1/4" x 14-1/4" cutout which is pretty standard on RV's. If you meant to write Dometic instead of domestic then yes it'll fit in your existing…

view full answer...

Answer 10

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

Hey Matt, Furrion typically has 4 wires running to their thermostats and the Chill Cube Thermostat #LC74DX is no exception. The harness you see with the thermostat would plug into the Chill Cube's controller and has 4 wires to extra wire to to…

view full answer...

Is the Advent Air Replacement RV Air Conditioner for Dometic Setup a "Vent"

Continue Researching