What to Do with Start Nut When Cutting Support Peg For Stromberg Carlson RV Ladder
Published 06/14/2019
Products Featured in This Question
Question:
How does the internal nut come out for cutting and re- afterwards? I have 3 to put in. Thanks.
asked by: Larry H
0
Expert Reply:
When trimming the Ladder Support Peg # 8531-B for your Stromberg Carlson RV Ladder # LA-401BA you will first take the cap off the end that attaches to the ladder. With the cap off simply push that star shaped nut further down into the tube before cutting it to your desired length. This will eliminate the hassle of actually removing the nut having to install it back into place.
expert reply by:
Chris R
0
Product Page this Question was Asked From
Replacement Standoff for Stromberg Carlson Exterior RV Ladders - Qty 1
- Accessories and Parts
- RV Ladders
- Support Peg
- Stromberg Carlson
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Steps, Motor, and Control for Kwikee RV 27 Series Electric Steps
- Q&A: Looking For Black RV Ladder Standoff
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Q&A: Exterior Ladder Replacement for 30ft 2017 Thor Motorhome
- Q&A: Why Can't The MaxxFan Plus Roof Vent MA00-04500K Be Used Above A Shower?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Replacement Lippert Control Module for Kwikee Step 1510000140
- Q&A: Replacement Motor 1101422 for Kwikee Step Assembly
- Q&A: Replacement Gear for Kwikee Steps 9010000220 On Fleetwood Bounder Motorhome