Can Self Tapping Screws Be Used To Install the Jensen RV Antenna Part # 44US01R

Question

Question:

I will be removing an existing antenna and wanted to know if this pkg contains self tapping screws. My concern is I can’t get under the roof . Also curious if self screws will properly attach the antenna to an aluminum roof. Thanks

asked by: Troy

0

Expert Reply:

The Jensen Antenna part # 44US01R comes with bolts/nuts not self tapping screws. However, you can add these using part # 1131832 (3). In regards to strength, the self tapping screws will hold the antenna just fine on your roof so there will be no issues here.

expert reply by: Conner L

0

Bruce F.

4/26/2020

how would this work on an aluminum boat and would it ground to the aluminum

Chris R.

4/27/2020

Aluminum doesn't provide a very good ground so with a lot of boat trailers you just have to get a bit creative. You could run a separate ground wire to the closest nearby steel plate or add a bracket to the frame for this use.

Answer 1

We do offer various different antennas for RV stereos like the Jensen Antenna part #44US01R or part #JAN139. The difference mostly comes down to mast length, mount type, and cable length. The actual plug which goes into the stereo is universal so you…

view full answer...

Answer 2

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 3

Hey Matt, the etrailer scissor jacks part #e56VV would be a great set of stabilizer jacks to replace what you have on your 2013 Viking 1404 GS. Scissor jacks like this basically all install the same way and are universal so these would for sure fit…

view full answer...

Answer 4

Hey Edwin, The Skylight #SR89YR will work perfectly fine with your 1-1/4" thick roof on your 2018 Lance 1575, though they typically will require some trimming to the garnish to fit perfectly. You will want to pick up 2 tubes of self leveling…

view full answer...

Answer 5

Hey Andy, the Ventline Roof Vent part #V3092-603-00 does not include a garnish. You can pair this with either the Polar White #VA0445-33 or Birch White #VA0445-25 ceiling garnish which is designed to fit roofs 7/8" to 2" thick. How thick is…

view full answer...

Answer 6

Hey Dale, thanks for reaching out. For your 2010 Toyota Tundra with the factory tow package, a proportional controller is definitely the way to go for smooth braking on a 2-axle trailer, and a really clean option is the Redarc Tow-Pro Liberty…

view full answer...

Answer 7

If your stove is a Furrion 2 in one, part #FSRE17SABL, FSRE17SASS, FSRE21SABL, or FSRE21SASS, the replacement stove top which includes the glass bifold panel is part #C-FSRE21SA-SS-003. If you have a different Furrion stove, I might be able to assist…

view full answer...

Answer 8

The prep you mentioned is more than adequate prior to applying the Alpha Systems 4034 Roof Coating for RV Roofs #AL34CV. According to the instructions you only need to apply the Primer #AL77CV if you're applying this to an EPDM membrane. In that…

view full answer...

Answer 9

I wasn't able to find the bolt pattern for your J-2500 stabilizer jacks, but the great thing about scissor jacks is that if the bolt patterns don't match up you can just unbolt the mounting brackets from the jacks and swap them over to the…

view full answer...

Can Self Tapping Screws Be Used To Install the Jensen RV Antenna Part # 44US01R

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching