Removing the Exhaust to Install Curt Hitch on 2019 Jeep Cherokee

Question

Question:

I have been trying to install this thing for the last 4 hrs. I cant get the hitch on the frame because of the 2 pins that were loosened and taken off wont let the exhaust down far enough to slide the hitch up. The next clamp on the system is up front attached to the cat converter. Do i have to take this clamp off and if so,will it let me be able to the exhaust far enough to put the hitch up? Is there a video that shows how to do this?

asked by: DUSTY E

1

Helpful Expert Reply:

There is not a video available as of this writing (June 2019) but there is a clamp just forward of the muffler that needs to be loosened so you can remove the rear portion of the exhaust from your 2019 Jeep Cherokee to install the Curt Trailer Hitch # C13395. You mentioned loosening two pins but you should start by removing the two bolts holding the hanger bracket.

If you take a look at the linked directions it does outline this.

expert reply by: Kyle S

1

Answer 1

While there is one hitch for your 2021 Jeep Cherokee Trailhawk that exits through the bumper, the #e73ZR does not, as the receiver will be below the bumper of your Jeep. The only option for a hitch that protrudes the bumper of your Cherokee Trailhawk…

view full answer...

Answer 2

Sorry about the confusion. The Curt #C13398 and #C13171 and the etrailer brand #e73ZR would all fit the 2019 Jeep Cherokee Trailhawk. Of the various options, a top choice would be the etrailer #e73ZR because once installed it would be the most…

view full answer...

Answer 3

The best method for locating the correct wires to splice into on your 2019 Jeep Cherokee when installing the Tow Ready Taillight Diode System #TR118821 is to simply test them using a circuit tester like #PTW2993. Going by wire color alone isn't…

view full answer...

Answer 4

Both the Curt #C13395 and #C13171 Class III hitches fit all models of the 2019 Cherokee, including your Overland model. The #C13171 would be fully visible once installed, while the #C13395 would have the hitch crossbar tucked up behind the bumper,…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

There are three differences in the two receivers. The etrailer Hitch item #e73ZR mounts slightly higher and will offer more ground clearance but the installation is more difficult. The Curt Trailer Hitch Receiver item #C13395 has a higher towing and…

view full answer...

Answer 7

Thanks for the pictures! The ground clearance of the etrailer Hitch item #e73ZR on a 2019 Jeep Cherokee is right at 9-1/2" to the bottom of the safety chain loops. This dimension will vary depending on passenger/cargo load, tire condition (brand…

view full answer...

Answer 8

I have a great hitch for your 2019 Jeep Cherokee Latitude. It is the etrailer Hitch item #e73ZR. This custom fit hitch bolts directly to your Cherokee's frame with included hardware. This is a class III hitch with a 2" receiver. It has a…

view full answer...

Removing the Exhaust to Install Curt Hitch on 2019 Jeep Cherokee

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching