Chrome Wheel Center Cap for 5-1/8 Inch Diameter Pilot Hole

Question

Question:

Do you carry 5 1/8inch pilot hole chrome rear wheel covers

asked by: Jim

0

Expert Reply:

Yes, for a 5-1/8" or 5.12" diameter chrome wheel center cap we have the Americana Trailer Wheel Center Cap part # AM90083 which is actually the only center cap we have in this size at this time. If you have EZ lube axles then you can simply remove the center cap for maintenance so you don't have to take off the entire wheel.

expert reply by: Conner L

0

Answer 1

Hey Robert, our trailer wheel and tire combos like the Strider ST235/80R16 Radial Trailer Tire w/ 16" Revolver Black Mod Wheel #TA27AR are not balanced as generally people don't balance trailer wheels. The weights don't stay on trailer…

view full answer...

Answer 2

We have two options for trailer wheel center caps that fit pilot holes with a diameter of just over 5 inches, which I'll list for you: - 5.12" Pilot Diameter: Americana Trailer Wheel Center Cap - 5.12" - Chrome #AM90083 - 5.15"…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The offset of a wheel refers to the distance between the mounting surface of the wheel that touches the hub and the center line of the wheel. A negative offset will move the tire away from the trailer, while a positive offset will move the tire…

view full answer...

Answer 5

Hey Austin, for trailer wheels like what we carry the vast majority of them have a zero offset. Most of the time this is listed in the descriptions but if it's not then it would be safe to assume it's zero. If it's not zero though it will…

view full answer...

Answer 6

The term modular refers to the style of holes that you see in the rim. The mod or modular wheels have 10 smaller holes that are just to the outside of the mounting flange. It's basically an appearance thing. Spoke wheels have more triangular…

view full answer...

Answer 7

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Chrome Wheel Center Cap for 5-1/8 Inch Diameter Pilot Hole

Product Page this Question was Asked From

Continue Researching