How to Install the Advent Air Rooftop RV Air Conditioner # ACM135 on an Enclosed Car Trailer
Updated 05/16/2019 | Published 05/15/2019
Products Featured in This Question
Question:
I have a bare car trailer with exposed steel ceiling joists and an aluminum roof. There is no interior. I’m concerned that the ACM 135 that I ordered from you won’t mount properly without some sort of ceiling that would effectively make the roof thicker and separate the exterior and interior components. I can’t find requirements about that.
asked by: Jason J
Expert Reply:
I do have something that you can reference but so far (May 2019) we haven't had the opportunity to install an AC unit like the Advent Air # ACM135 on an enclosed trailer like what you have.
We have, however, installed the MaxxFan Deluxe Roof Vent # MA00-06200K on a 2018 Nissan NV 2500 which I have linked the installation video for you to check out. In this video we use some plywood to take up some gaps and to give some more stability to the vent unit. Since both the MaxxFan and the Advent Air units use the same 14-1/4" x 14-1/4" opening size you should be able to take this and apply it to your situation (although you might have to adjust for any differences with your application).
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: accarkit
- Search Results: acm135
- Q&A: Solution for Replacement for Discontinued Carrier AC Unit 68RV14102A
- Q&A: Replacement AC Unit for RV with Dual Dometic Units that will Use Same Controls
- Shop: RV Roof Membrane
- Shop: RV Covers
- Shop: RV Mattress
- Search Results: acdom150
- Shop: Adco SFS AquaShed RV Cover for Travel Trailers up to 31' Long - Gray
- Shop: Ventline Ventadome Trailer Roof Vent - Manual - 14-1/4" x 14-1/4" - White - Birch Trim
- Q&A: How To Install The Advent Air RV Air Conditioner System With ACTH12 Thermostat
- Q&A: Wiring Diagram for the Dometic Replacement Single Zone Thermostat