Is Lippert Jack Foot Plate LC165253 Compatible with Dutton-Lainson 5K Topwind Jack DL22772

Question

Question:

Will this foot pad fit the tube and hole size on a Dutton Lainson 5000 lb top wind jack? Thanks for your help!

asked by: David A

0

Expert Reply:

Yes, Dutton-Lainson 5K Topwind Jack # DL22772 has a 2-inch diameter inner jack tube which will fit fine in the Lippert Jack Foot Pad # LC165253. We also offer a Dutton-Lainson foot plate # DL22542 which is made for this jack that includes the snapper pin to secure the foot to the tube. For a snapper pin to use with the Lippert foot plate use part # JFC-PN.

expert reply by: Adam R

0

Answer 1

There are some Dutton-Lainson trailer jacks that are made in the USA as well as a few that are not. Any jacks that we carry that are made in the USA have that as part of the description to help set them apart. Currently we have the following options:…

view full answer...

Answer 2

The A-Frame Trailer Jack - Topwind - 5,000 lbs. by Dutton-Lainson #DL22772 does not have a grease zerk fitting integrated, sor do any of our other top wind jacks. This doesn't mean they are difficult to maintain, but they do not have that…

view full answer...

Answer 3

Hi Robert; I'm assuming you mean can the #DL22772 use a drop leg that would adjust up and down. If you can find one that fits and matches the capacity then yes, you could use a drop leg. However, we only offer a standard foot like the #DL22542…

view full answer...

Answer 4

The closest equivalent manual jack, to the Lippert item #LC285318, would be the Buyers Products A-Frame Jack w/ Support Foot - 15" Travel - 5,000 lbs item #3370091265. This jack has the standard A-Frame jack 3" diamond pattern. I have…

view full answer...

Answer 5

A trailer jack only lifts part of the weight of the trailer and not the whole 10,000 pounds of your trailer. A 10K trailer would have a tongue weight of around 1,000 to 1,500 pounds. But the higher the capacity of the jack the easier it is for the…

view full answer...

Answer 6

I went out to our warehouse to take a look at the Buyers Products A-Frame Jack #3370091265 referenced in your question. I measured a height from the mounting bracket up to the top of the tube (before the handle) of just about 9-1/2 inches. I have…

view full answer...

Answer 7

The mounting bolt pattern of the Buyers Products A-Frame Jack #3370091265 is 3" all the way around. The mounting holes are elongated though so if you have a slightly larger/smaller distance it should still work out.

view full answer...

Answer 8

For your 10,000 lb car hauler trailer, I recommend the Round A-Frame Trailer Jack - Sidewind - 15-5/8" Travel - 5,000 lbs #TJA-5000S-B for a manual jack, with footplate #JF-99. The majority of the weight of your trailer will be on your axles and…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Is Lippert Jack Foot Plate LC165253 Compatible with Dutton-Lainson 5K Topwind Jack DL22772

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching