Can Dutton-Lainson A-Frame Trailer Jack Use Drop Leg
Updated 12/15/2025 | Published 11/11/2024
Products Featured in This Question
Question:
Your 5k jack. Part number DL22772. Can you put adjustable foot on thatone that slides in?
asked by: Robert K
0
Expert Reply:
Hi Robert; I'm assuming you mean can the # DL22772 use a drop leg that would adjust up and down. If you can find one that fits and matches the capacity then yes, you could use a drop leg. However, we only offer a standard foot like the # DL22542 for this trailer jack and others like it.
expert reply by:
Robin H
0
Product Page this Question was Asked From
A-Frame Trailer Jack - Topwind - 5,000 lbs. by Dutton-Lainson
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- A-Frame Jacks
- Topwind Jack
- 4001 - 5000 lbs
- Manual Jack
- 15 Inch Lift
- Bolt-On
- Weld-On
- No Wheel or Foot
- Dutton-Lainson
more information >
Continue Researching
- Shop: Loadstar ST225/75D15 Bias Trailer Tire with 15" White Wheel - 6 on 5-1/2 - Load Range D
- Shop: Round A-Frame Trailer Jack - Sidewind - 15-5/8" Travel - 5,000 lbs
- Shop: Buyers Products A-Frame Jack w/ Support Foot - 15" Travel - 5,000 lbs
- Shop: Round A-Frame Trailer Jack - Topwind - 15" Travel - 3,000 lbs
- Shop: Ultimate Trailer Jack - A-Frame - Topwind - 27-1/2" Lift - 2,000 lbs
- Video: A-Frame Trailer Jack: The Breakdown
- Video: Bulldog Trailer Jack BD018564 Review
- Video: A Closer Look at the Dutton-Lainson A-Frame Topwind Trailer Jack
- Q&A: Is Lippert Jack Foot Plate LC165253 Compatible with Dutton-Lainson 5K Topwind Jack DL22772
- Q&A: Trailer Jacks Manufactured in the USA
- Q&A: Availability of 5,000 lb Top Wind Trailer Jack with Grease Zerk Fitting
- Video: A Closer Look at the Buyers Products A-Frame Jack w/ Support Foot
- Q&A: Manual A-frame Jack Replacement for Lippert Electric Trailer Jack
- Q&A: Recommended Tongue Jack for 10,000 lb Car Hauler Trailer
- Q&A: Height of Buyers Products A-Frame Jack # 3370091265 without Handle
- Q&A: Mounting Bolt Hole Pattern for the Buyers Products A-Frame Jack # 3370091265
- Shop: Replacement Foot Plate for Lippert Power Gear Hydraulic Jack
- Shop: Footplate for 2,000-lb and 5,000-lb Round, A-Frame Jacks
Robin H.
12/15/2025
Hey Robert, did you end up using the standard foot for your 5k Dutton-Lainson jack? Knowing what worked could help others looking for the same setup.