Replacement Grease Seals for Dexter Part # 010-036-00 on a 7,000lb Trailer Axle  

Hey Mike, there isn't a way to get just the pump of the assembly you are in need of so the only solution would be the part #LC251910 that you referenced.

The correct replacement control module for your Kwikee Steps with Control Module 909513 is the Lippert Components Kwikee Control Unit part #LC379606.

There is one tire pressure monitoring system I really like over the rest, which is from TireMinder; the reason I like this system is because it is easy to use, compatible with Bluetooth, and best of all, highly accurate, with a margin of error of…

We have the 3/4" Conical Washer #3232 and 3/4" Bolt #090747 that is 4-1/2" long. There is also the 3/4" Nut #F2135823295 with the same 16 threads per inch as the bolt.

The correct replacement leaf spring bushings for any given trailer will be dependent on the width and type of the leaf springs. The most common for a Dexter 10,000 lb Trailer Axle are 3" wide slipper springs. If you have 3" wide…

It sounds like you have an equalizer bolt like part #7-136-2-6-112 as opposed to one with a hex head like the part #7-169-6-112. This is fine as long as the diameter and length matches what you're needing. When installing suspension bolts on…

The Grease Seals 10-36 (pair) #RG06-070 cross references as the fit for your 010-036-00 seal. This seal has an inner diameter of 2.250 inches and outer diameter of 3.376 inches. The Grease Seal - Double Lip - 2.250" ID - 3.376" OD…

To convert a 5,200 lb Dexter hub to be oil bath all you really need is the kit part #XLPROLUBE2440KIT. This comes with the correct cap and seal as well as the oil needed to make the conversion.

When installing your Easy Grease Trailer Idler Hub Assembly for 2K Axles - 4 on 4 - Pre-Greased #AKIHUB-440-2-EZ-1K there should not be any "play" or space. Since it is pre-greased, more grease is not needed. I recommend checking your…

Yes, you want your entire hub completely filled with grease. This prevents the grease from being flung out of the bearings. If your spindle does not have a grease zerk like the #TRU74FR to fill the hub with grease you can use a device like the…

After you've packed the bearings and assembled everything, carefully slide the hub assembly onto the spindle and install the outer bearing. Install the spindle and tang washer and run the spindle nut down finger tight, then rotate the hub back…

The ring terminal size you need for the posts of the junction box part #3375601101 that you referenced is 3/16 inch like the part #44-5310A which would work great. The terminal matches the correct ring size and also is designed for 10 to 12 gauge…