Ultimate Overview of the Grease Seals 10-36 (pair) Video

The free backing Titan Hydraulic Brake Kit #T4489600-500 are indeed a replacement for DICO brakes that measure 12" x 2" so they will work for you. You just need to make sure you need a capacity for a 6,000 lb axle and have a 5-bolt mounting…

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

Since the trailer was off of the ground it would not take much voltage to stop the wheels from spinning so they may be getting power but they may not be getting enough power due to a short or wiring issue. But 9 times out of 10 weak trailer brakes…

Yes, the Timbken bearings part #TMK73VR and #TMK23VR are made in the USA.

We do have the Replacement Step Latch #MR97BR you can order for the MORryde Step Above RV steps. This latch mounts to the left side of the step as you are facing the door from outside the camper.

I spoke with Lippert and they confirmed that SolidStep Manual Fold-Down Steps for 29" to 36" Wide RV Door Frames #LC791575 does not have a quick hinge function, just manual fold down and raise up. We do offer the Torklift GlowStep…

I spoke to MORryde about your steps and they informed me that you could convert to a removeable mounting plate by getting rid of the strut assist and you would then just need the Replacement Step Latch for MORryde Step Above RV Steps part #MR97BR and…

The Removable Mounting Plate for MORryde StepAbove RV Steps part #MR92AR is not compatible with strut assist. If you have a model with strut assist you'll need to remove the assembly before you can install the mounting plate.

The Removable Mounting Plate for MORryde StepAbove RV Steps part #MR92AR only measures 27-5/8" wide so although designed for 30" - 32" doorways, will work with a 29.5" doorway.

Yes, the bearing kit part #BK3-210 does fit a good portion of the 7,000 lb Dexter axles out there, but some of the 7k Dexter axles require a slightly larger grease seal which instead requires the kit part #BK3-200. What you'll want to do is…

Yes, the Grease Seals 10-36 #RG06-070 that you referenced does have a garter spring as it is the exact same seal as your Dexter seal K71-305-00.

The Dexter Electric Trailer Brake Assembly #23-429 & #23-428 have a center opening of 3-7/8" for fitting on the axle tube. It will mount to bolt holes that are 3-5/8" spread left to right and 4-3/8" top to bottom. I have included…