Troubleshooting Lippert Electric Stabilizer Jack Clicking and Not Raising
Updated 03/11/2019 | Published 03/08/2019 >
Products Featured in This Question
Question:
Lippert stabilizer clicking Our 2019 Coleman 285 BH rear stabilizer will not go up. when we attempt to raise it makes a clicking sound
asked by: Ryum
Expert Reply:
The clicking you are hearing sounds like a circuit breaker being stripped and auto resetting. This indicates there is either a wiring issue or the motor is drawing more power than it should. Check the ground wire connection at the battery to ensure the connection to the trailer frame is bare metal to metal.
I recommend first checking the trailer battery using a multimeter like # PT89ZR. If the voltage is good at the battery, then inspect the wiring leading to the switch. Next test the voltage at the switch entering the switch and then also leaving the switch when activated. If this is not consistent, you have a bad switch.
Inspect the wire going from the switch to the motor and make sure you have correct voltage at the motor in both directions. If one direction pulls more than the other that is normal because lifting the trailer will take more power because it is lifting the weight to stabilize where lowering will have the help of gravity and the weight of the trailer.
If you need to replace the motor, the part you are seeking is the Replacement Electric RV Stabilizer Jack Motor for Lippert Components Landing Gear - Rear # LC352338. If the jack has been overextended there is a rod that runs the length of the stabilizer that may be bound up or in worst case bent. These jacks are stabilizers an not intended to raise or level the trailer without sometimes needing blocks. Using the jack as a leveling style jack instead of stabilizing can overextend the jack.
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: trailer dolly
- Shop: Parkit360 Force Electric Trailer Dolly - 2" and 2-5/16" Hitch Balls - 10,000 lbs
- Shop: Replacement Electric RV Stabilizer Jack Motor for Lippert Landing Gear
- Q&A: Lippert Stabilizer Jack is Clicking
- Shop: Stromberg Carlson Electric Landing Gear Set - Weld On - 34-7/8" Lift - 6,500 lbs
- Shop: Stromberg Carlson Manual Landing Gear Set - Weld On - 34-7/8" Lift - 8,000 lbs
- Shop: Landing Gear Set - 36-1/2" Lift - 8,000 lbs
- Shop: Stromberg Carlson Electric Landing Gear Set - Weld On - 34-7/8" Lift - 6,500 lbs
- Video: Ultimate Overview of the Stromberg Carlson Electric Landing Gear Set
- Q&A: Replacement Motor for Landing Gear with 1A-065012-02-01 Motor
- Q&A: Replacement Landing Gear for 1998 Carriage Carri-Lite RK 732
- Search Results: trailer jack motor
- Search Results: rv leveling blocks
- Search Results: camper jacks
- Search Results: wheel chocks
- Search Results: 10 inch jack foot rv jack pads
- Search Results: 120v rv stoves and ovens
- Shop: Suspension Enhancement
- Shop: SumoSprings Rebel Custom Helper Springs - 2 Piece - Front Axle
- Video: Global Link Locking Baggage Lock Actuator Set Installation - 2011 Forest River Flagstaff Classic Sup
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Video: Firestone Ride-Rite Air Bags with Easy Mount Compressor Feature Breakdown
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Shop: Trailer Wiring
- Video: Curt T-Connector Vehicle Wiring Harness Review C56040
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Choose the Right Trailer Hitch Class


