Can the Spring Seats Be Moved on the Dexter 3,500 LB Drop Axle
Updated 02/19/2019 | Published 02/17/2019
Products Featured in This Question
Question:
Can I get this axle with a spring center to center of 70.5? What is the overall length?
asked by: Robert
Expert Reply:
The Dexter Trailer Axle Beam with 4" Drop E-Z Lube Spindles part # 8327812 measures 89" long between each hub face and 74" long between each spring center. It is not offered with 89" between each hub face and 70-1/2" long between each spring center because the spring seats can be moved. The spring seats for this axle can be moved to a minimum of 75" apart and a maximum of 71" apart. Since you only need to go in 1/4" more on either side I would say you are fine to move the spring seats on this axle to sit 70-1/2" apart. In order to do this you will need to cut off the spring seats that come with the axle and then tack weld part # TRSS238 on.
The overall length of the Dexter Trailer Axle Beam is 93" from end to end.
Product Page this Question was Asked From
Dexter Trailer Axle Beam with 4" Drop E-Z Lube Spindles - 89" Long - 3,500 lbs
- Trailer Axles
- Leaf Spring Suspension
- Standard Grade
- No Hubs
- 3500 lbs
- Spindles Only
- 74 Inch Spring Center
- 89 Inch Hub Face
- Drop - 4 Inch
- Dexter
more information >
Continue Researching
- Search Results: st185/80d13
- Shop: TruRyde 3,500-lb E-Z Lube 4" Drop Spindle w/ 4-Bolt Flange for 3" Tube
- Q&A: What is the Difference Between Load Range C and D ST175/80D13 Trailer Tires
- Shop: Dexter Trailer Axle Beam with 4" Drop E-Z Lube Spindles - 89" Long - 3,500 lbs
- Shop: Trailer Idler Hub Assembly for 2,000-lb Axles - 4 on 4 - Galvanized
- Shop: Square BT8 Spindle for 2,000-lb Trailer Axles - 1-1/2" Wide
- Shop: CE Smith Trailer Hub Assembly w/ Carrying Case for 2,500-lb Axles - 4 on 4 - Pre-Greased - Threaded
- Shop: Loadstar ST175/80D13 Bias Trailer Tire with 13" White Wheel - 4 on 4 - Load Range C
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: What Gauge Wire Should be Used When Installing Brake Assemblies on a Trailer
- Q&A: Recommended Wire Gauge for Wiring Trailer Brakes
- Q&A: Gauge Wire Recommendation for Wiring up Trailer Brakes
- Q&A: Replacement Axle for 2007 Fleetwood Bayside Camper
- Q&A: How To Choose Correct 3,500 Lb Axle for Slipper Spring Setup
- Shop: Dexter Trailer Axle Beam with Standard Spindles - 89" Long - 3,500 lbs
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Do Trailer Axle Spring Seats Weld to Axles
- Search Results: leaf spring seat
- Search Results: dexter equalizer
- Search Results: dexter leaf spring suspension
- Search Results: e47sr
- Search Results: dexter 8 247
- Search Results: k71~359~00