Tire Pressure Rating for Tire Size of 205/65-10

Question

Question:

Proper inflation for 205/65-10?

asked by: Bill

0

Expert Reply:

Trailer tires should always be inflated to the max PSI rating that is on the sidewall of the trailer. The same size tire may have different pressure ratings based on Load Ranges, brands etc.

For the size you listed of 205/65-10 common pressure ratings are:

Load Range B: 910 lbs at 35 psi
Load Range C: 1,100 lbs at 50 psi
Load Range D: 1,330 lbs at 70 psi
Load Range E: 1,650 lbs at 90 psi

The part # AM1HP52 that you referenced should be inflated to 50 psi.

expert reply by: Jameson C

0

Larry

2/28/2026

Does the Load Range exclude the trailers weight?

Jameson C.

3/2/2026

@Larry The Load Range is the capacity per tire to hold the weight of a trailer so no it does not exclude that.

Answer 1

The 205/65-10 trailer tire size comes in different load ranges and each load range has a different psi requirement. A load range B in this size should be inflated to 35 psi. Load range C inflate to 50 psi. For load range D inflate to 70 psi. And for…

view full answer...

Answer 2

That's a fantastic idea! You would need to cut the wire on either side of the fuse holder and wire in enough wire to either side of it so that you could reposition it wherever you felt would be the most convenient. We sell 12 gauge wire by the…

view full answer...

Answer 3

If you've replaced the 10A fuse in the yellow fuse holder where the power wire for the taillight converter of the #118561 wiring harness attaches to the vehicle battery and you're still not getting any power output to the trailer, then the…

view full answer...

Answer 4

I am sorry to hear that you are having an issue with the running light circuit of the Curt Vehicle Wiring Harness #C56158 not working on your 2013 Honda CR-V EX. It sounds like you have gone through most of the troubleshooting steps so I recommend…

view full answer...

Answer 5

It sounds like you may have forgotten to install one of the two included fuses of the Curt Harness part #C56158. The larger fuse that goes in the red fuse holder powers the entire converter so without it the lights wouldn't function. You can test…

view full answer...

Answer 6

The first thing you are going to want to do is take a circuit tester and test the red wire just before it enters the converter box. If you do not have power here then test this wire again just before the fuse holder. If still no power then there is…

view full answer...

Answer 7

The Curt T-Connector Vehicle Wring Harness, #C56158, is designed to bypass pulling electric from your 2015 Honda CR-V's lighting wiring and get power directly from the vehicle's battery. The T-Connector harness includes a powered light…

view full answer...

Answer 8

First thing you should do at this point is test the 4-way of the wiring harness with a circuit tester part #PTW2993 for voltage on all of the right pins when the taillight signals are being applied. Just like in the video I attached. If the voltage…

view full answer...

Answer 9

Curt does a really good job on the hitch side of things but when it comes to the electronic side of things they are definitely not my first choice simply because we tend to have more issues with their wiring simply giving out like what you…

view full answer...

Answer 10

Hey Joseph, Our trailer tires like #AM30150 do not come balanced. A trailer tire does not need to be balance like a normal vehicles tire would, so ours do not come balanced. Although it never hurts to do it, it is not necessary. Trailer tires are…

view full answer...

Answer 11

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...