Are Trailer Wheels Made with 5 Lug Bolt Patterns

Question

Question:

Do you have 5lug rims also?

asked by: Joe N

0

Expert Reply:

We do have 5 lug rims like the # AM3S331 that you referenced. This wheel and tire has a bolt pattern of 5 on 4-1/2 inches. We have a few different 5 lug bolt patterns though so you may want to check out the help article I attached that covers how to determine what bolt pattern you have first.

expert reply by: Jameson C

0

Answer 1

Trailer or automotive wheels can have a positive or negative offset. The offset refers to the distance between the mounting surface of the wheel that touches the hub and the center line of the wheel, as shown in the diagram I have edited for you. A…

view full answer...

Answer 2

The Taskmaster Steel 8-Spoke Trailer Wheel #TA49RR is the correct wheel for mounting a ST145/R12 Radial Trailer Tire #AM10130. Do note this wheel has the most common 5 on 4-1/2" bolt pattern and you will want to verify that is the correct bolt…

view full answer...

Answer 3

Yes, you are able to put a smaller tire on the trailer to lower it, however there are a few things that you want to consider when choosing a smaller tire. According to my research the standard tires that are on your trailer are ST175/80R 13LRC tires…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Are Trailer Wheels Made with 5 Lug Bolt Patterns

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching