Diameter of Mounting Hole Base for Gustafson Glass for RV Pendant and Sidewall Lights

Question

Question:

2014 Grand Design Solitude fifth wheel mdl ST369RL diameter of mounting hole at base

asked by: Harry S

0

Expert Reply:

The opening in the Gustafson Glass for RV Pendant and Sidewall Lights # 277-000430 that connects to the base has a 1" diameter. I have attached a photo to demonstrate.

expert reply by: Jon G

0

click to enlarge

Answer 1

Looks like our replacement shade part #277-000473 might be what you are in need of. If your current shade measured 6 inches tall and 4-1/8 inches in diameter this would be the correct fit. We also have the slightly larger part #277-000474 which…

view full answer...

Answer 2

The Gustafson RV Pendant Light Shade #277-000430 has a 1-1/16" opening in the top of the shade. The glass is 2-1/16" wide at the top and inside the shade the width is 1-3/4" across for the nut that holds the shade to the light fixture…

view full answer...

Answer 3

Yes, both the outer and inner shade pieces of the Gustafson RV LED Pendant Light #277-000422 are replaceable. For the inner white swirl shade you would use part #277-000430 and for the outer glass you would use part #277-000431. I have attached a…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 11

Hello Sam; that is a great question! I reached out to Furrion and you will be able to use the Furrion Chill Cube #FR69TD (white) or #FR49TD (black) with your furnace. However, the remote is not capable of operating the furnace at this time. Also, we…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Diameter of Mounting Hole Base for Gustafson Glass for RV Pendant and Sidewall Lights

Product Page this Question was Asked From

Continue Researching