Fuse Location for 7-Way 12V Power Pin on a 2010 Ford F-250
Published 11/14/2018 >
Products Featured in This Question
Question:
Is there a fuse somewhere else other than fuse #33 in the cab which i checked and is good
asked by: Mike
0
Expert Reply:
Check fuse 44 in the fuse block under the hood of your 2010 Ford F-250 as well as the relay in position 56. According to the online version of your owner's manual these are also related to the 12V power pin on your F-250.
If those look good then the next thing you can do is use a circuit tester with a probe like part # PTW2991 and check the 12V wire from your 7-Way to your battery. Replace any pieces that are damaged or pinched with 10 Gauge Wire # 10-1-1.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Featured Help Information
Instructions
Continue Researching
- Search Results: sm99251
- Search Results: demco
- Search Results: bx7380
- Search Results: rm~15267
- Search Results: bx2258
- Search Results: hm39524
- Search Results: gooseneck
- Shop: Vehicle Tow Bar Brake System
- Video: Ultimate Overview of the SoftStartRV Soft Start for Single Zone Air Conditioner Setup
- Shop: Vehicle Tow Bar Wiring
- Shop: Roadmaster 4-Diode Universal Wiring Kit for Towed Vehicles - 7-Way to 6-Way Coiled Adapter Cord
- Shop: SoftStartRV Soft Start for Single Zone Air Conditioner Setup - Qty 1
- Video: Review of the Blue Ox SwayPro Weight Distribution w/ Sway Control for 2" Hitch
- Shop: Blue Ox SwayPro Weight Distribution w/ Sway Control for 2" Hitch - 7.5K GTW, 750 lbs TW
- Shop: Reese Weight Distribution - No Shank - Trunnion Bar - 15,000 lbs GTW, 1,500 lbs TW
- Shop: Dexter Electric Trailer Brake Kit - 12-1/4" - Left and Right Hand Assemblies - 8,000 lbs
- Shop: Reese Weight Distribution System w/ Shank - Trunnion Bar - 12,000 lbs GTW, 1,200 lbs TW
- Shop: Blue Ox SwayPro Weight Distribution w/ Sway Control for 2" Hitch - 10,000 lbs GTW, 1,000 lbs TW
- Shop: Trailer Wiring
- Video: Review of the T-One Vehicle Wiring Harness for Factory Tow Package-118261
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Difference Between 1 Diode and 3 Diode Red 2" x 4" Clearance Lights
- Q&A: What is The Thread Pitch For the Spindle Nut on a Dexter 10K Axle?
- Article: Trailer Wiring Diagrams
- Q&A: Location of Brake Controller Port on 2015 Toyota Tundra
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Compatibility of Curt 5th Wheel Hitch With Lippert Turning Point Rotating Pin Box
- Q&A: Goose Box and 5th Wheel to Gooseneck Adapter for a Turning Point Pin Box
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Q&A: Replacement For TDE LP75 Disc Brake Actuator

