USA Made Trailer Tire Size 225/75-15 Recommendation

Question

Question:

Hi, we have a 98 mallard fleetwood 25 foot and need to buy tires right now we have 225/75 15r but not sure about the ply or load range? Which tires will be best?

asked by: Heather L

0

Expert Reply:

For your tire size of 225/75-15 I recommend the Karrier ST225/75R15 # AM10303 They have a weight capacity of 2,830 lbs and a speed rating of 81 mph. . This will work great on your Fleetwood Mallard! These have a ply rating of 10. This weight capacity is adequate for the trailer.

expert reply by: Jameson C

0

Answer 1

Goodyear Endurance trailer tires are the only USA made trailer tire out there. In the size of 225/75-15 that you referenced we have a Goodyear part #724857519 which is definitely your best choice. These have the best tread design, warranty, speed…

view full answer...

Answer 2

It sounds like the seal you have has an inner diameter of 2.25 inches and outer diameter of 3.371 inches. For a pair of seals this size we have #RG06-070. This is a set of two 10-36 double lip seals. We also have set #RG06-090 which has an inner…

view full answer...

Answer 3

That is correct. The #GS-2250DL is the direct replacement for your old grease seal marked P02860 on your 2019 Keystone Cougar.

view full answer...

Answer 4

One thing to note when using a hitch extender like the etrailer, #e88YR, is that the tongue weight and towing capacity of your trailer hitch will be reduced by 50 percent due to the increased leverage that is placed on your trailer hitch from your…

view full answer...

Answer 5

This is a great question that there isn't exactly a great answer for. Hitch extenders not only put the weight further away from the hitch which would increase the leverage on the hitch, but they also add movement to the assembly which will…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hi Mark; the only jack like that is the Lippert Power Stance Electric Trailer Jack #LC89VR but it exceeds the amount you're looking to spend. If you're fine with one that only runs off of the 7-way then I recommend the etrailer Electric…

view full answer...

Answer 10

Hey Nate, We do not have a 3/4" spindle nut or washer, the smallest option is the 7/8" spindle nut #165931and a 1" washer #SW1000. I cannot find anything smaller. Are you sure the threads on you're spindle are 3/4"? If they…

view full answer...

Answer 11

Hello Jeremy, Yes, our etrailer jack #e55ZV will automatically stop and not over raise. If you check out the video that I attached you will see that Steven still has his finger pushing down the button after the jack stops. What kind of application…

view full answer...

Answer 12

To check the pins on the vehicle side 7-Way, you can use a circuit tester or the volt meter. The circuit tester will show you if a signal is coming through on the pin you are testing while the volt meter will tell you that and how much voltage is…

view full answer...

USA Made Trailer Tire Size 225/75-15 Recommendation

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching