Which Axle of Tandem Axle Trailer Normally has Brake Axle
Updated 07/06/2020 | Published 10/16/2018
Question:
5 x 10’ dump bed utility trailer. Tandem 3500 axels. Electric brakes factory installed on the rear axel only. Shouldn’t the front axel have brakes sine more weight in front? Is there any reason I shouldn’t put brakes on all 4 wheels? Can I add a manual raking brake also? Is front or rear axel best for the parking brake?
asked by: Ray
Expert Reply:
It's not uncommon for a tandem axle trailer to have brakes on only one axle. Typically for utility trailers which have more weight towards the front the front axle is the one that will have the brakes and trailers like boat trailers which carry more weight towards the rear of them will have the brake axle as the rear one. The same concept would be applied for parking brakes as well. If your trailer has an electric dump that would put more weight at the rear of it than usual with the hydraulics so having the brakes on the rear axle would not surprise me.
Product Page this Question was Asked From
Dexter Electric Trailer Brake Assembly w/ Parking Brake - 10" - Left Hand - 3,500 lbs
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- LH
- 3500 lbs
- Brake Assembly
- Manual Adjust
- 10 x 2-1/4 Inch Drum
- Dexter
more information >
Continue Researching
- Search Results: trailer brakes
- Search Results: trailer light kit
- Search Results: led trailer light kit
- Search Results: trailer bearings races seals caps
- Shop: Brake Controller
- Shop: Lippert Complete Bearing Kit for 6,000-lb Trailer Axles - 15123/25580 Bearings, 15245/25520 Races
- Shop: Lippert Complete Bearing Kit for 3.5K Trailer Axles - L44649/L68149 Bearings, L44610/L68111 Races
- Search Results: 13322
- Search Results: trailer deck screws
- Search Results: trailer tie down anchors
- Article: Trailer Lighting Requirements
- Shop: Trailer Hitch
- Video: Review of etrailer Trailer Hubs and Drums - Hub with Drum - AKHD-545-35-EZ-K
- Shop: etrailer Electric Trailer Brakes - 10" - Left/Right Hand Assemblies - 3,500 lbs
- Shop: Hydraulic Brake Kit - Uni-Servo - Free Backing - Dacromet - 12" - Left/Right Hand - 5.2K to 7K
- Shop: Hydraulic Brake - Uni-Servo - Free Backing - Dacromet - 12" - Right Hand - 5,200 lb to 7,000 lb
- Video: What to Know About the Demco Hydraulic Brake Line Kit for Single Axle Trailers
- Shop: Trailer Axle Beam with Easy Grease Spindles - 4" Drop - 89" Long - 3,500 lbs
- Shop: etrailer Electric Trailer Brakes - Self-Adjusting - 10" - Left/Right Hand Assemblies - 3.5K
- Video: Comprehensive Review: Demco Hydraulic Brake Kit
- Shop: Trailer Wiring
- Video: Review of Kenda Trailer Tires and Wheels - Tire Only - KE75TJ
- Video: Feature Review Tandem Axle Trailer Fenders
- Q&A: How to Select Replacement Hydraulic Drum Brake Assembly for Calkins Boat Trailer
- Video: Feature Breakdown: Dexter Zinc-Plated Brake Actuator
- Video: Ultimate Overview of the 2-1/4" Long Torx; Floor Screws, 40/Pkg
- Q&A: Comparing Uni-Servo and Free Backing Hydraulic Drum Trailer Brakes
- Q&A: Recommended Safety Chains or Cables for 14k Horse Trailer.
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Trailer Wiring Diagrams
on Accessories and Parts
William
6/30/2020
What about two axles trailer that is not in tandem configuration? I'm making a two-axles utility trailer which has steerable front axle and a fix rear axle. The wheelbase between the axles is about 1500mm and is not in tandem configuration. The GVW of this trailer is about 3000 kg. In this case which axle should have a brake? Or do I have to install brake on both axle?