Will Dexter Torflex Lift Kit Work on Different Torsion Axle
Updated 08/27/2018 | Published 08/24/2018
Question:
I replaced the original axles on my trailer with the ones in the attached photo, no problem. I’d like some lift due to bottoming out on inclines etc. The kit I would like to use is the tandem axle 2 5/8” lift. I’m concerned about the bolt pattern. Can you tell by the information on the axle in the attached photo if it will fit? Cheers
asked by: Adam S
Expert Reply:
The Dexter Torflex Lift Kit # K71-707-02 that you referenced is only confirmed to fit Dexter #10 Torflex axles that have a 2,300 to 4,000 pound capacity. It's possible that it will fit other torsion axles like what you have on your trailer, but it has not been officially tested. Looking at the picture you attached of your axle I cannot be sure if it will work or not.
I went out to our warehouse to measure the bolt pattern on these spacers and found that the bolts are spaced apart exactly 8 inches on center. Also note that they cannot be used on torsion axles with 3 inch high profile brackets. You can use this information to see if this might work on your trailer.
Product Page this Question was Asked From
Torflex Lift Kit - Tandem Axle - 2-5/8" Lift
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Tandem Axle
- Dexter
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Torflex Lift Kit - Single Axle - 2-5/8" Lift
- Shop: Torflex Lift Kit - Tandem Axle - 2-5/8" Lift
- Video: Feature Breakdown: Torflex Lift Kit
- Shop: Torflex Lift Kit - Tandem Axle - 2-7/8" Lift
- Shop: Torflex Lift Kit - Single Axle - 2-5/8" Lift
- Shop: Torflex Lift Kit - Tandem Axle - 3-1/8" Lift
- Video: Torflex Lift Kit Review
- Shop: Torflex Lift Kit - Single Axle - 2-7/8" Lift
- Video: A Closer Look at the Torflex Lift Kit
- Search Results: dexter torsion axle lift kit
- Search Results: suspension enhancement
- Search Results: accessories and parts
- Shop: Correct Track Trailer Alignment and Lift Kit - Single Axle
- Video: Installing the Dexter Torflex Lift Kit
- Video: Complete Breakdown of the Torflex Lift Kit
- Q&A: Lift Kit For Dexter #11 Torflex Axle and Measuring Brackets To Ensure Fitment
- Q&A: Upgrading 4400 Pound Axle To 6000 Pounds
- Q&A: How to Lift a LOOK Trailer with Torsion Axles
- Q&A: Where Do Each of the Wires of the Tekonsha Breakaway System part # 50-85-313 Run
- Q&A: Correct Way to Wire Trailer Breakaway Kit
- Shop: Blind Spot Detection
- Q&A: Will The Torflex Lift Kit For A #11 Torsion Axle Fit A #12 Torsion Axle
- Video: Replacement Drive Head Pin for Solera Power RV Awnings: The Breakdown
- Article: Trailer Wiring Diagrams
- Shop: Trailer Hitch
- Search Results: trailer hitch
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Trailer Wiring
- Search Results: trailer wiring
on Trailer Suspension Parts
