How to Install the Pollak 6-Pole Trailer Wiring Connector Part # PK11604 on a Horse Trailer

Updated 07/12/2018 | Published 07/10/2018

Question:

Have wires way diagram shows have running lights only right blinker works

asked by: Steve

Expert Reply:

I have attached a photo that shows how the Pollak 6-Pole Round Pin Trailer Wiring Connector part # PK11604 will need to be wired. In order to make sure that you are installing the correct wires into the correct pins you will want to use a separate battery and power each of the lights on the trailer's wiring harness while checking for continuity with a circuit tester like part # ALL640595. This will also allow you to see if power is not going through the wires that lead to the taillights. In which case you would want to first inspect the bulbs and then the wires.

expert reply by: Conner L