Locating Brake Controller Plug-In Harness on 2012 Georgetown Class A Motorhome

Updated 07/11/2018 | Published 07/10/2018

Question:

Do you know where the wire harness is located on a 2012 Georgetown class a

asked by: Rich

Expert Reply:

Based on my research, your 2012 Georgetown Class A Motorhome is built on the Ford F-53 chassis. If this is correct, you will just need the Plug-In Wiring Adapter # 3035-P to install a trailer brake controller like the excellent Tekonsha Prodigy P3 # 90195.

One end of the harness will plug into the brake controller itself while the other end will connect with the factory port beneath the dash of your RV. This should be located near the emergency brake release lever. It will be a gray square connector. Sometimes the plug can be buried behind other wires and it just needs to be fished out.

expert reply by: Chris R