Can Prodigy P3 Brake Controller part # 90195 be Installed in a Motorhome with Air Brakes

Question

Question:

I have a 2010 Newmar Ventans diesel pusher motorhome with air brakes . Will this control the electric brakes on a car hauler trailer?

asked by: Sam

1

Helpful Expert Reply:

Yes, the Prodigy P3 part # 90195 can be installed in a motorhome with air brakes and can activate the electric brakes of a trailer. All that is needed for the controller is a brake signal to tell the controller to start applying trailer brakes. Typically this is found at the brake pedal switch for the stoplights of the trailer. Sometimes it can be found at the third brake light.

expert reply by: Jameson C

1

Answer 1

The Curt Echo Mobile Trailer Brake Controller - Wireless - Proportional #C51180 will work well on your 2007 Fleetwood Discovery and the air brakes will have zero impact on its function. It has an integrated inertia sensor to determine deceleration…

view full answer...

Answer 2

Hi Jack, A proportional trailer brake controller is a great option for a motorhome with air brakes, as it will sense your rig slowing down and apply the amount of braking power needed, and it just requires your motorhome's brake lights to…

view full answer...

Answer 3

Based on my research, your 2012 Georgetown Class A Motorhome is built on the Ford F-53 chassis. If this is correct, you will just need the Plug-In Wiring Adapter #3035-P to install a trailer brake controller like the excellent Tekonsha Prodigy P3…

view full answer...

Answer 4

Although any of the Brake Controllers that we offer would work, I would recommend a proportional controller. A proportional controller can sense how quickly the tow vehicle is braking, and send enough voltage to the brakes on the dolly so that the…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Can Prodigy P3 Brake Controller part # 90195 be Installed in a Motorhome with Air Brakes

Featured Help Information

Miscellaneous Media

Continue Researching