Adjusting a Self-Adjusting Brake Assembly on 8K Axle to Easily Remove Drum
Updated 06/20/2018 | Published 06/18/2018 >
Products Featured in This Question
Question:
Had brake lockup on one wheel of trailer . How do I back off self adjusting brake, shoe is to tight against drum to pull drum off 8k electric self adjusting drum brake
asked by: Dan M
0
Expert Reply:
The Self-adjusting Brake Assemblies like # AKEBRK-8 still have a manual adjuster to allow you to relieve that brake shoe pressure. You simply remove the plug on the back of the assembly and adjust the manual dial using a small screwdriver or brake adjuster spoon like # W80630. I've attached a video to assist.
expert reply by:
Jason S
0
Product Page this Question was Asked From
etrailer Electric Trailer Brakes w/ Dust Shields - Self-Adjusting - 12-1/4" - Left/Right - 8K
- Trailer Brakes
- Electric Drum Brakes
- Standard Grade
- Self Adjust
- 12-1/4 x 3-3/8 Inch Drum
- 8000 lbs Axle
- 15 Inch Wheel
- 16 Inch Wheel
- 16-1/2 Inch Wheel
- 17 Inch Wheel
- 17-1/2 Inch Wheel
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: self contained hydraulic jack
- Search Results: hydraulic jack
- Search Results: thinline led
- Shop: Dexter Self-Contained Hydraulic Jack - Square Tube - 20" Lift - 10,000 lbs - Bolt On
- Shop: Bigfoot Self-Contained Hydraulic Trailer Jack w/ Manual Override - 24" Lift - 8K lbs - Bolt On
- Search Results: trailer leaf springs
- Search Results: trailer door holders
- Search Results: trailer door hinges
- Search Results: slipper springs
- Shop: Coleman-Mach Mach-C Everest Thermostat
- Shop: Unitized Oil Seal - I.D. 2.875" / O.D. 3.880" for Select 9K-10K Dexter Axles - Qty 1
- Shop: RV Designer Roller Catches w/ Prong - Qty 2
- Q&A: How to Tighten Self Adjusting Brake Assemblies by Hand
- Shop: U-Bolt Kit for Mounting 5,200-lb to 7,000-lb, Round Trailer Axles - 7" Long U-Bolts
- Shop: Dexter Trailer Hub Drum Assembly - 9K to 10K - 8 on 6.5 - Oil Bath - Non-ABS Drum - After July 2009
- Video: Feature Breakdown: Horst Miracle Probe Sensors for RV Gray Water Tanks
- Shop: Camper Tie-Downs
- Shop: Trailer Hitch
- Video: A Closer Look at the Timken Bearing Kit for Lippert, Dexter, and AL-KO Axles
- Video: Let’s Check Out the Timken Grease and Oil Seal
- Q&A: Lug Nuts for a Brinkley Z3100 5th Wheel Camper
- Q&A: How Tight Should the Spindle Nut be on a Dexter 8,000 Pound Axle
- Video: What to Know About the Front/Center/Rear Hanger for Double-Eye Springs
- Video: Curt Adjustable Width RV Trailer Hitch Installation - 2016 Keystone Hideout Travel Trailer
- Q&A: What Are the Specs for the Lippert 2 Inch Trailer Hitch Receiver LC730647
- Q&A: How To Adjust Lippert Self-Adjusting Braking Assemblies
- Q&A: Bolt-On Trailer Hitch for a 2018 Vanleigh Vilano 5th Wheel Trailer
- Video: All About the Replacement Magnet Clips for Electric Brake Assemblies (Qty 4)
- Q&A: Weight Of The MORryde Cushioned 5th Wheel Pin Box # MR84VR
- Shop: Brake Controller



