Replacement Roof Vent Lid for 2008 Sundowner Sunlite 777 Trailer

Question

Question:

i have a 2008 sundowner sunlite 777. the dressing room vent cap plastic is broken. is that piece replaceable or do i need the whole assembly?

asked by: Louie

0

Expert Reply:

I could not find any photos showing the roof of your 2008 Sundowner Sunlite 777 but if your plastic vent lid is the common 14 x 14-inch size we can help you with a replacement lid.

We offer replacement lids in each of the more common hinge styles. The linked page displays all lids and the photo I included shows the four different hinge types. Simply identify your hinge type and click on it; you can do the same for your preferred color.

For example, for a white lid with continuous hinge use part # BV0554-01.

expert reply by: Adam R

0

click to enlarge

Sean A.

6/6/2020

do you have a completely flat plastic lid just like the metal one above?

Answer 1

The Redline 36 Inch Side-Door Bar Lock Assembly, #305736, can be used on the right and left side. The image on our product page shows it in the left hand orientation, but it can be used on the right hand side by flipping it upside down. Check out the…

view full answer...

Answer 2

We offer a replacement metal roof vent cover that fits the standard 14 x 14-inch roof vents that are typically found on RVs. Ventline part #BV0534-00 is a plain metal finish flat lid with a continuous type hinge. This is the only metal lid we offer…

view full answer...

Answer 3

The majority of square trailer roof vents are a standard size, about 14 x 14-inches. I found a few photos of your StarCraft camper trailer and it does appear that this is the size on yours. The replacement vent lids we offer come in many colors and…

view full answer...

Answer 4

Diamond Cargo's website does not provide any details about the roof vents installed in their car hauler trailers but since most trailer roof vents are the square 14 x 14 size chances are good that is what you have. We offer all types of roof vent…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 8

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Replacement Roof Vent Lid for 2008 Sundowner Sunlite 777 Trailer

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching