Where to Mount Converter Box When Installing Trailer Wiring for 2006 Saturn Vue
Updated 04/18/2018 | Published 04/17/2018
Products Featured in This Question
Question:
Where am I supposed to mount or hid this converter box it says inside vehicle.... Thats impossible to get it inside vehicle or is it says mount behide the taillight out side the vehicle
asked by: Ryan
Expert Reply:
With the install of the Curt trailer wiring harness part # C56018 that you referenced Curt recommends finding a flat spot inside the vehicle near the taillight to adhere the box to in step 6.
When we had the chance to install the similar Tekonsha kit part # 118418 on a 2006 Saturn Vue like yours we mounted the box in the driver side rear taillight area. If you check out the 1:00 mark of the video you'll see our installer mention this although it's not shown.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Visible
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Recommended Hitch for a 2014 Chevy Equinox
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: How to Wire Epicord 277-000137 30 Amp Twist Lock Power Inlet
- Q&A: Wiring Diagram for Furrion Chill
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: How to Tell if 2006 Saturn Vue is Redline or Not for Picking Out Trailer Hitch
- Q&A: What are the Torque Specs for the Draw-Tite Trailer Hitch Receiver # 75876
- Q&A: Is Weight Capacity for One Tire or the Whole Trailer
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)