2016 Chevy Factory Integrated Brake Controller Compatibility With Electric Over Hydraulic Actuators

Question

Question:

Have 2016 Chevy 3500 pickup with factory installed brake controller. Plan on installing electric over hydraulic brakes on fifth wheel trailer. Is this controller comparable with all the brake actuators you sell. Thanks

asked by: Ron

1

Helpful Expert Reply:

The factory brake controller in your 2016 Chevy 3500 is compatible with all of our Electric Over Hydraulic Actuators when you use the HydraStar Electric Over Hydraulic Actuator Adapter Module for Ford and Chevy Brake Controllers # HBA-CAM. This will work with any of our EOH actuators to ensure a good connection without error messages.

My recommendation is to use the HydraStar Electric Over Hydraulic Actuator Kit for Disc Brakes - 1,600 psi # HBA16-252-82 or the Kit for Drum Brakes - 1,000 psi # HBA-10-252-82.

expert reply by: Jason S

1

Answer 1

Some trucks do need an under-the-hood connection of wiring to activate the 12V trailer power feed and the trailer brake controller power input feed. This process is outlined and illustrated in the linked article, in the section titled…

view full answer...

Answer 2

The correct grease/dust cap size for your Kodiak Disc Brake Kit #K2HR526D is 2.44". For EZ Lube grease caps with this dimension we have part #RG04-080 which comes in a quantity of 2. If you are wanting to upgrade to Bearing Buddys (which would…

view full answer...

Answer 3

We can offer you a choice of two handle lengths as replacements for your Dutton Lainson Winch. Part #DL70336 is a 6-inch long handle and part #DL70330 is a 9-1/2-inch long handle. Both fit their DL3200 winch. You may be able to use either depending…

view full answer...

Answer 4

If it is a 1000 psi then it would be the Hydrastar for drum brakes. The newest one is #HBA-10 and it has different wire colors, see picture. So you know that black is 12 volt power in and white is the ground. Blue/white goes to the break away switch.…

view full answer...

Answer 5

When installing an equalizer like the Equalizer for 2" Wide Slipper Springs - 11" Long - 7/8" Center Hole #TREQ1304 there is no specific torque setting for the bolts. The correct installation process is to tighten the eye bolts until…

view full answer...

Answer 6

As you can see on the attached photo, the wiring diagram for the actuator shows there can be a 25-40 amp circuit breaker in-line with the black wiring which goes from the battery's positive terminal to power the actuator. This is actually only…

view full answer...

Answer 7

Hi Shane; sometimes the adapter module #HBA-CAM is needed to help the brakes function properly. However, before you go this route I would check out the brake controller. More often than not you need to switch to electric over hydraulic mode for the…

view full answer...

Answer 8

The factory trailer brake controllers are not good options for trailers with electric over hydraulic brakes. There are adapters that you can use to be made compatible, the HydraStar Electric Over Hydraulic Actuator Adapter Module part #HBA-CAM but…

view full answer...

Answer 9

Like you said, many factory integrated brake controllers will not work well with electric over hydraulic trailer braking systems. Some of the newer versions of these controllers now have an electric over hydraulic mode. Check to see if any of your…

view full answer...

Answer 10

Yes! The Hydrastar Electric Over Hydraulic Actuator for Disc Brakes #HBA16 will work with the integrated brake controller on 2018 and newer GMC Trucks. 2017 and older GMC trucks require the HydraStar Electric Over Hydraulic Adapter Module #HBA-CAM to…

view full answer...

Answer 11

Wiring connections for the Electric Over Hydraulic Brake Actuator are as follows. Yellow - Cold side of breakaway switch, The wire that goes hot when a breakaway occurs. Black - Positive connection on breakaway switch, The wire that charges the…

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

2016 Chevy Factory Integrated Brake Controller Compatibility With Electric Over Hydraulic Actuators

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching