Tube Dimensions of Pro Series Round A-Frame Jack Part # PSEA20000340

Question

Question:

Will this work with my Dutton DL22537 wheel. What are the tube diameters and the pin hole diameter? Thanks

asked by: James H

0

Expert Reply:

The inner tube that extends and retracts, and that the wheel would attach to, on the Round A-Frame Jack, part # PSEA20000340 measures 2 inches at its outside diameter and 1.85 inches inside diameter. The pin hole measures .4 of an inch. These measurements were taken with a digital caliper.

expert reply by: Mike L

0

click to enlarge

Answer 1

Thanks for the picture of the a-frame jack mounting bolt hole dimensions you have. Based on that we know you have a standard jack mount on your trailer and the Stromberg Carlson Electric Trailer Jack #JET-5000 you are interested in is a confirmed fit…

view full answer...

Answer 2

I went out to the warehouse and measured a Bulldog A-frame trailer jack, #BD155032. The bolt holes are 3 inches apart on center. I measured a few other A-frame jacks that were nearby and they also had holes that were 3 inches apart on center.

view full answer...

Answer 3

There isn't a particular bolt length that is recommended for installing an A-Frame jack like the Pro Series #PSEA20000340 that you were looking at. This is simply because it will really depend on the trailer it is being installed on, as some will…

view full answer...

Answer 4

When the Pipe Mount Swivel Style Trailer Jack with Foot - Topwind - 15" Travel - 2,000 lbs. #DL22682 is fully extended the distance from the center of the weld-on spud to the foot is 29-3/4 inches. When this is fully retracted the distance is…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

To check the pins on the vehicle side 7-Way, you can use a circuit tester or the volt meter. The circuit tester will show you if a signal is coming through on the pin you are testing while the volt meter will tell you that and how much voltage is…

view full answer...

Answer 7

Hi Mark; the only jack like that is the Lippert Power Stance Electric Trailer Jack #LC89VR but it exceeds the amount you're looking to spend. If you're fine with one that only runs off of the 7-way then I recommend the etrailer Electric…

view full answer...

Answer 8

Hey Seth, The etrailer Electric Trailer Jack w/ 7-Way - Drop Leg - A-Frame - 18" Lift - 5K #e74GV may work on your 2015 Ford F-250, but there's a high chance that it won't straight out of the box. On 2015 and newer Ford trucks with a…

view full answer...

Tube Dimensions of Pro Series Round A-Frame Jack Part # PSEA20000340

Continue Researching