Replacement Spindle for Procraft Trailer

Question

Question:

I have a procraft trailer iI need a new spindle the old one is Number BT151

asked by: Wayne H

0

Expert Reply:

I was unable to reference a spindle with the number BT151; the best I could find in reference to BT151 is a hub kit for an E-Z Loader trailer, though it did not mention the specific bearings it used which would help identify which spindle you need. Knowing your axle capacity will also help narrow down your choices, or you can measure your spindle with a digital caliper where the bearings and grease seal ride and use that information to compare it to the chart on the Trailer Spindles page I've linked to find a match.

expert reply by: Kyle S

0

click to enlarge

Answer 1

Hey Kevin, Thanks for your question. We actually don't carry any Load Range E trailer tires in the ST205/75R14 size. The highest load rating we offer in that size is Load Range D, which provides a capacity of 2,200 lbs per tire. Based on the…

view full answer...

Answer 2

Hey Tyler, yes the CE Smith trailer hub part #CE13315 that you referenced would work for you as this was designed to fit a straight spindle that is 1-1/16 inch in diameter. This has the very common 5 on 4-1/2 bolt pattern too. If you have a 5 lug…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 8

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 12

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Replacement Spindle for Procraft Trailer

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching