Replacement EZ Loader Trailer Hub for Spindle that is 1-1/6 inch in Diameter
Updated 10/30/2025 | Published 02/26/2025
Question:
I have an ez loader EWR 14-18 1 1/16inch straight spindle trailer with 300-020883 hubs on it. I want to replace them. Is there a compatible hub i can use?
asked by: Tyler J
0
Expert Reply:
Hey Tyler, yes the CE Smith trailer hub part # CE13315 that you referenced would work for you as this was designed to fit a straight spindle that is 1-1/16 inch in diameter. This has the very common 5 on 4-1/2 bolt pattern too. If you have a 5 lug bolt pattern most likely this is correct but if not let me know.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
CE Smith Trailer Idler Hub Assembly w/ Case for 2.7K Axles - 5 on 4-1/2 - Galvanized - Pre-Greased
- Trailer Hubs and Drums
- Idler Hub
- Pre-Greased
- Standard
- L44649 / L44649
- Marine Grade
- For 2700 lbs Axles
- 1/2 Inch Stud
- 5 on 4-1/2 Inch
- 13 Inch Wheel
- 14 Inch Wheel
- CE Smith
more information >
Continue Researching
- Q&A: What Is the Difference Between a BTR and BT8 Spindle
- Q&A: Replacement Hubs for a Triton 08351 PWC Trailer Axle
- Q&A: Replacement Hubs for 2,700 lb Axle
- Q&A: Replacement Hubs For EZ Loader Trailer With 2,500 lb Axles
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Is There a Trailer Hub that Fits Spindle with 1.06 inch Bearing and 1.25 inch Grease Seal
- Q&A: Replacing Short Hubs On A 1996 EZ Loader Trailer With Straight Spindles
- Q&A: What Size Dust Cap Does The Dexter Idler Hub DX77UR Use?
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Wiring Diagrams
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How To Measure And Replace Everything In Your Hub Assembly
- Article: How to Measure a Trailer Axle
Jameson C.
10/30/2025
Hey Tyler, how did the CE Smith trailer hub work out on your EZ Loader trailer? Your update could make it easier for others trying to match hubs to a straight 1-1/16 inch spindle.