Light Color and Lumen Output for Opti-Brite LED Dome Light # ILL28CMPG

Question

Question:

How many LUMENS ? is it Daylight, white light ?

asked by: Robert

0

Expert Reply:

The Opti-Brite LED Dome Light # ILL28CMPG puts out white light. The raw lumen output is 1,400 lumen. The effective lumen output is 990 lumen.

expert reply by: Michael H

0

Answer 1

It sounds to me like there might be a blown fuse or just a lack of voltage causing your issues with the Opti-Brite 12V/24V LED Dome Light for Refrigerated Trucks and Trailers #ILL28CMB. These lights can operate on 7v to 30v DC power so I recommend…

view full answer...

Answer 2

I spoke with my contact at Optronics and they informed me that the Optronics light part #ILL28CMB will sense movement up to 6 feet away and will remain on until no movement is sensed for 2-1/2 minutes. The sensitivity and duration are not…

view full answer...

Answer 3

Hi Curtis; unfortunately, the timer on the Opti-Brite 12V/24V LED Dome Light for Refrigerated Trucks and Trailers #ILL28CMPG is not adjustable.

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 11

Hello Bruce, Thanks for writing in! Using butyl tape between the trailer body and the Single Axle Jeep Style Trailer Fender - Diamond Plate Aluminum - 13" to 15" #HP96VR is exactly the route I would go. It stays flexible, creates an…

view full answer...

Light Color and Lumen Output for Opti-Brite LED Dome Light # ILL28CMPG

Product Page this Question was Asked From

Continue Researching