18-1/4" x 5-3/4" Rectangle. LED dome light provides bright light in extreme temperatures. Motion sensor activates light when motion detected. Durable polycarbonate housing. Surface mount. 2-Wire design with 0.180 male bullets. 8 Diodes.
Features:
Specs:
Lumens are used to measure the amount of usable light that is put out by a light source. Raw lumens represent the number of lumens that the manufacturer claims the LEDs are capable of producing. It does not include the light's drive method or the amount of light lost from the lens or reflector. Effective lumens take these factors into account and represent the number of lumens that are actually produced by the complete light assembly, not just the amount of light that the diodes are capable of producing. This light has a 1,400 raw lumen capacity and produces 990 effective lumens.
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Speaker 1: Today we're taking a look at the Optronics Opti Bright LED Dome light. This is designed for use in extreme temperatures so it's ideal for refrigerated trucks and trailers. It will withstand temperatures from negative 40 degrees fahrenheit to positive 140 degrees fahrenheit. Directly in the center it features the motion sensor so the light will come on automatically when motion is detected. Operating voltage is 7 to 30 volts DC. Voltage cutoff at 7 volts prevents battery drain.
So again, voltage cutoff is at 7 volts direct current and that prevents battery drain.You can use this with 12 volt and 24 volt DC systems. The light output remains consistent at all operating voltages and cuts off when the voltage is outside of range. Now this is an LED system. LED's make great replacements for incandescent lights. They last longer, they burn brighter and they are much more efficient.
You don't have to worry about replacing bulbs and you don't have to worry about brittle filaments with LED systems.It's a two wire design so you have you have your white wire, which is ground and black wire which is your power lead. And on the ends of the wiring we have the .180 male bullet connectors. If you don't want those on there, you can cut them off, strip back the wiring for hard wire applications. It features polycarbonate lens and housing, it's very strong and durable. We're looking at a clear lens with a white base.
When it comes to the installation, that's a recess mount installation. Mounting hardware not included but you will need to cutout for this portion right here in order for the light to sit flush.Now when it comes to the overall dimension. I took a measurement from edge to edge, got a measurement of 18 1/4" long. Side to side, we're looking at about 5 3/4" wide. And the overall thickness, or the overall depth, so from very front to very back is 1 1/8" thick.
Now from the installation surface to the front of the unit is only about 3/8" thick. So it's a nice low profile design once installed. The mount holds on the unit. You can see you have numerous mount holes around the perimeter of the light. These holes right here are separated on center by 2 3/16", these are separated on center by 4 3/4" and then this set to this set on center is 17 1/8". Your cutout needs to measure around 16 1/2" long by 4" wide.We're going to go and hook it up to power, that way you can see what it looks like with some power running to it. We'll also be able to turn off our overhead lights so you can see it in a lower light setting. So you can see here it sends out a very bright consistent signal. It's a nice bright light that has multiple LED's or multiple daioids so the multi daioids design helps optimize the overall light output. The raw lumen, when it comes to the brightness the raw lumen is 1400. Effective lumen output is 990. Power draw at 12.8 volts, 1.61 amps. Power draw at 24 volts 0.80 amps. And Optronics puts a life time warranty on the LED'sThat's gonna do it for today's look at the Optronics Opti Bright LED Dome Light.
Average Customer Rating: 4.8 out of 5 stars (267 Customer Reviews)
18-1/4" x 5-3/4" Rectangle. LED dome light provides bright light in extreme temperatures. Motion sensor activates light when motion detected. Durable polycarbonate housing. Surface mount. 2-Wire design with 0.180 male bullets. 8 Diodes.Customer loved the light. He is purchasing them himself
QUICK FAST SHIPPING
Work great still in use today. Perfect for box trucks, the motion prevents drivers leaving the switch on draining the battery
Exactly what I was looking for and needed.Replaced a dim incandescent light with an LED.
I will be using these to replace 4' fluorescent in a 28' enclosed trailer. I have not yet installed them, however I connected them to 12-volt power and they are very bright. The flush mount design will make it very easy to install without any retrofitting or needing to do cut outs.
I installed 4 of these lights low on the wall to assist in lighting the tie down anchors and straps in my car hauler trailer. They are very bright and easy to mount with 4 screws. These 4 lights and the 3 ceiling lights that I purchased from etrailer.com work great in making an enclosed trailer very bright inside. The surface mount makes these lights AAA+.
this was a great product, and an easy swap out. We have had it nearly a year now with no problems.
Great service, quick response time, I will work with etrailers in the future!
Added 4 of these during a rustic hunting cabin lighting project. These are for the shed and provide awesome lighting. I didn't realize the back side of the shed door was cream colored because we never closed the door before due to needing all the light we could get. Because it is a shed and we run these off of batteries I used a standard bathroom fan timer switch to make sure the lights don't get left on forever.
These are fantastic. Replaced two main lights, both controlled by a wall mounted switch, in our 21' travel trailer. The additional light from these is amazing. We can now see inside the cupboards and closets without needing a flashlight. Installation was easy and straightforward, just remember that LEDs are polarity specific. Also keep in mind that these do not have a switch in them, which is why I only replaced the two main lights. We like them so well we just ordered another to replace the bathroom light, also controlled by a wall switch. I would replace all the lights with these if they had internal switches.
These lights are outstanding. They are slim design and bright. Easy to install. You do have to provide your own screws and wire connections, which does allow you the ability to choose what works best. Great product and highly recommended. The brightness is amazing for such a small thin light.
I ORDERED A DOME LITE FOR OUR 2021 NOMAD TOYHAULER & IT WAS A PERFECT FIT.VERY EASY TO INSTALL & THE SALES PEOPLE ARE VERY KNOWLEDGEABLE & HELPFULL. I WOULD HIGHLY RECOMMEND THEM FOR ANY PARTS YOU NEED FOR YOUR CAMPER.
Great light output. I used them in my enclosed racecar trailer - lots of light and very little battery draw.
I cant say enough good things about these excellent lighting fixtures! I have (2) of these fictures install in my 20' Box - they are low profile, sensor operated and absolutely make it a pleasure and also very safe to work in this space. Make the investment, you will not regret it! Also, the etrailer customer service is absolutely outstanding, with excellent communication and follow up!
Dimmable option is a great plus, have had no problems, will probably replace more fixtures in my trailer with these lights.
The lighting in my cargo trailer contained 4 incandescent fixtures that had burned out bulbs most of the time. They never were really bright even when all worked. I took this pair of photos at night so you can see the difference. The LED lights burn cooler, use less of my storage battery charge, and the bouncing of the highway won't harm them. Well worth the price and an easy installation.
Simple to install. Very bright. Capacitive touch on/off works well.
very bright . happy with low profile
Totally lights up every corner of my 6x6. Easy install, everything I need.
I installed as a cargo light in the bed topper on my truck. It was wired into existing bed lights and comes on when they do. It has added a significant amount of additional light and is working great.
Great replacement for the incandescent bulb lights for the engine compartment of our boat. Easy to install and a clean white light
Shipped quickly without unnecessary packaging. Installed easily, except for wire colors were either backwards in the light or the feed lines. So, after initially thinking the light didn’t work, I tried reversing the wires and it worked beautifully. Love the dimming feature. On full brightness it is very bright. Awesome.
I LOVE these lights they are clean daylight BRITE! They provide true color, easy reading, easy to install.
Thank you!
Great product, very simple install, much brighter than regular cargo trailer lights. Very Fast delivery, nice folks!!!
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.